Check-line CP-425-KIT User manual

 Checkline-Europe
-1-
TABLE OF CONTENTS
1.0 General ……………………………………………..………………… 2
2.0 Test procedure ……………………………………………………..… 2
3.0 Possible reasons for error ……………………………………….. 4
4.0 Storage ………………………………………………………………. 4
5.0 Warranty ………………………………………………………………. 5

 Checkline-Europe
-2-
1.0 GENERAL
The pins of the CP-425-KIT have to be free from dust, dirt, oil and dampness.
The ideal test temperature was defined at 23°C. However, a test temperature
between 20°C and 26°C is sufficient. Air humidity has to be between 30% r.h. and
80% r.h.
The device as well as the CP-425-KIT has to be stored in the same surroundings for
some time before testing. If you do not comply with these specifications this may
lead to deviations.
This manual declares the test of following devices:
• TMT-425 Digital Textile Moisture Meter
• TMT-425-USB Digital Textile Moisture Meter
2.0 TEST PROCEDURE
Switch on the TMT-425(USB) and switch to the calibration curve „test block“ using
the arrow keys.
Put the orange stick (CP-425-1) into the electrode holder.
free from dust, dirt, oil and dampness

 Checkline-Europe
-3-
Now your device should show the value 22,0% (+/-1,0%), as shown in the picture
below.
If the measuring value is blinking in grey, the value is beyond the stated
specifications (please read „possible reasons for errors). If the measuring value is
shown in black, the value is o.k.
Put the black stick (CP-425-2) into the electrode holder as shown in the picture
below.
Now your device should show the value 41,0% (+1,0%, -1,5%) in black, as shown
on the picture below.

 Checkline-Europe
-4-
3.0 POSSIBLE REASONS FOR ERRORS
Discrepancy in temperature between TMT-425(USB) and the CP-425-KIT
Please ensure that the device and the test block are being stored at
nearly the same temperature before measuring. A high temperature difference has a
negative effect on the stability of the measurement results.
Contact pressure is too low
Please pay attention to a good contact between the pins and the holder
Dirt
The pins of the CP-425-KIT are free from dust, dirt, oil and dampness. If the pins
become dirty, only clean them with a moistened lint-free cloth.
Wrong calibration curve
Please ensure the selection of the calibration curve „test block“ before starting the
testing.
4.0 STORAGE
The sticks can be put together for easy storage.
 Checkline-Europe
-5-
5.0 WARRANTY
Checkline Europe (Checkline) warrants to the original purchaser that this product is
of merchantable quality and confirms in kind and quality with the descriptions and
specifications thereof. Product failure or malfunction arising out of any defect in
workmanship or material in the product existing at the time of delivery thereof which
manifests itself within one year from the sale of such product, shall be remedied by
repair or replacement of such product, at Checkline’s option, except where
unauthorized repair, disassembly, tampering, abuse or misapplication has taken
place, as determined by Checkline. All returns for warranty or non-warranty repairs
and/or replacement must be authorized by Checkline, in advance, with all repacking
and shipping expenses to the address below to be borne by the purchaser.
THE FOREGOING WARRANTY’S IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO, THE
WARRANTY OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR
PURPOSE OR APPLICATION. CHECKLINE SHALL NOT BE RESPONSIBLE NOR
LIABLE FOR ANY CONSEQUENTIAL DAMAGE, OF ANY KIND OR NATURE,
RESULTING FROM THE USE OF SUPPLIED EQUIPMENT, WHETHER SUCH
DAMAGE OCCURS OR IS DISCOVERED BEFORE, UPON OR AFTER
REPLACEMENT OR REPAIR, AND WHETHER OR NOT SUCH DAMAGE IS
CAUSED BY MANUFACTURER’S OR SUPPLIER’S NEGLIGENCE WITHIN ONE
YEAR FROM INVOICE DATE.
Some State jurisdictions or States do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation may not apply to you.
The duration of any implied warranty, including, without limitation, fitness for any
particular purpose and merchantability with respect to this product, is limited to the
duration of the foregoing warranty. Some states do not allow limitations on how long
an implied warranty lasts but, not withstanding, this warranty, in the absence of such
limitations, shall extend for one year from the date of invoice.
CHECKLINE EUROPE
Dennenweg 225B, 7545 WE, Enschede
Tel: [phone] / Fax: [phone]
Every precaution has been taken in the preparation of this manual. Checkline-
Europe assumes no responsibility for errors or omissions. Neither is any liability
assumed for damages resulting from the use of information contained herein. Any
brand or product names mentioned herein are used for identification purposes only,
and are trademarks or registered trademarks of their respective holders.