Chicco KeyFit 35 Zip ClearTex Canopy User manual

PMS 2747 and PMS 186
WARNING: Avoid serious injury or death to your child. You
must read and understand the Canopy Features instructions and
the instructions in the User Guide. If you do not understand these
instructions, STOP and call Chicco at 1-877-424-4226.
INSTRUCTIONS: KeyFit®35 Zip ClearTex Canopy Features
IMPORTANT: Please also refer to the instructions that came with your product.
Open Canopy fully and locate the zipper on the Back Panel, as shown. Unzip the zipper slider and remove the
zipper pin from the retainer box to separate both sections of the zipper.
1
1
SS0027E_02
Canopy Mesh Panel:
Pull the Back Panel Fabric forward to lay flat over top
of the middle Canopy section.
2To close the Mesh Panel, pull the Back Panel Fabric
back over the Mesh Panel. Secure both sides of the Zipper
together and pull the zipper slider up and over the Canopy
to close off the Mesh Panel.
3

2
Fold up the Privacy Shield and lay it over the front
section of the Canopy. To avoid bunching, fold the
Privacy Shield once and lay flat inside the zipper pouch.
Pull the Front Panel Fabric forward and over the Privacy
Shield. Zip the Zipper closed.
7
To store the Privacy Shield, undo all 4 snap buttons.
6
Fabrics may be hand washed using mild soap and water, or machine washed in cold water on delicate cycle using mild
detergent. Canopy should be hand washed or wiped with a damp cloth and mild detergent. Hang to dry. DO NOT
BLEACH. Please consult your product manual for additional care and maintenance instructions.
Contact Chicco Customer Service at 1-877-424-4226 for assistance or additional information.
Cleaning Instructions:
With the Canopy fully open, locate the zipper on the Front Panel, as shown. Unzip the zipper and fold back the
front panel.
4
Canopy Privacy Shield:
Remove the Privacy Shield from the Front Panel section. Pull the Privacy Shield forward, and drape the shield
over the car seat. Secure the Privacy Shield using 4 snap buttons. Locate 2 snap buttons (a) on the front corners of the
car seat, as shown. Next locate and secure 2 snap buttons (b) below the seat belt guide on each side of the car seat, as
shown. Make sure the snaps are always secured. DO NOT let unsecured privacy shield hang loose.
5
3
a.
b.