Christie Vivid Red Guide

When the lamp reaches the end of its service life, the image will become
darker and colors lose their richness. When the lamp has been operating for
1400 hours or longer, the lamp status LED indicator will flash green, and the
message "The lamp is reaching its limits. Please replace the lamp as soon as
possible" will be displayed on the screen. Even though the lamp may still be
working, replace the lamp to maintain optimal projector performance. When
the lamp has been operated for 1500 hours, the message " LAMP
EXPIRED!!" will be shown on the screen, replace the lamp immediately.
DO NOT TOUCH THE LAMP immediately after it has been used. It will be
extremely hot. Allow the fan to finish its cooling process, then turn the
projector off, and disconnect the power cord. Allow at least for
the lamp to cool down before handling.
DO NOT REMOVE ANY SCREWS except the lamp cover screw and two
lamp housing screws. Removing other screws could result in electric
shock to the user.
If continuing to use the lamp after the replacing lamp message has been
displayed on screen, the lamp bulb may shatter, and pieces of glass
may scatter inside the projector and out into the room. Do not touch
them as the pieces of glass may cause injury. If this happens, contact
your dealer for lamp replacement.
one hour
CAUTION
VIVID Red
Lamp Replacement Instructions

To Replace the Lamp:
To Reset the Lamp Timer:
1. Loosen the lamp cover screw and remove the lamp cover.
2. Loosen the two screws securing the lamp housing. Remove the lamp
housing by pulling on the handle.
3. Insert a new lamp housing until it is plugged into the socket.
4. Secure it in place with the two screws.
5. Re-attach the lamp cover.
6. Tighten the lamp cover screw.
7. Reset the lamp timer.
1. Press Left button, Menu button, and Up button within one second on the
control keypad or remote control to enter engineering menu as shown:
2. Go to lamp reset sub-menu and move the cursor to Reset option. Press
Right button to select.
3. Lamp timer will reset to 0 hour usage.
There are two air filter sponges in the bottom of the Vivid Red projector to
capture dust or dirt and should be replaced whenever the lamp module is
replaced. The temperature will rise and the lamp will fail to light when the air
filters inside of the projector become dirty and clogged. Replacement will be
required more often if the projector is used in the a particularly dusty
environment.
Replacing the
Air Filter
1. Unplug the power cord from the socket.
2. Remove the small filter holder and
unscrew the big air filter screw.
3. Detach the air filters.
4. Replace the air filters.
5. Install the air filters.
6. Re-install the filter covers.