
Assembly
It is necessary to assemble twheels to the platform as follows:
Slide a wheel on to each end of the axle, ensuring a collar is in place up against
the axle bracket, and secure the wheel using a split pin provided.
Folding and Unfolding the Truck
To lower the platform, simply pull it down until it snaps into place. To raise it - pull it
up until it lies flat against the Back Support.
To raise the handle, push the bar, in the centre of Back Support, forwards firmly
against spring pressure and pull the handle upwards until it locks into place.
To lower the handle, again push the bar forwards and push the handle down to
the bottom of its’ travel.
Specifications
Max. Capacity ......................................... 90kg
Dimemsions - Folded (LxWxH) ............... 721x406x182mm
Dimensions - Overall (LxWxH) ................ 412x406x1090mm
Weight (packed) ..................................... 7kg
Part No. ..................................................... 6500180
Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE
International reserve the right to change specifications at any time without prior notice.
Safety Precautions
1. Do not exceed the stated capacity of the truck.
2. Load the platform evenly with the centre of gravity of the load over the
centre of the platform.
3. Do not bounce the truck over rough ground, or down curbs etc., use ramps.
4. Do not transport an extremely large load which may impair your forward view.
5. Take extra care if transporting a wide load.