Classic Accessories Overdrive PermaPRO User manual

Instructions: PermaPRO™
WARNING!
Cover for storage use only.
Donot occupy the
RV while cover is on
the RV.
Do not run the RV engine with the
cover on.
WARNING!
Installation is best done with two people
and on most RVs requires working from
the roof of the RV. Never install on a
windy day or when the roof is slippery or
wet. Please take care when you are on a
ladder or the roof.
Be sure that your helper does not pull the
cover while you are on top of the RV.
CAUTION
Installation and removal is safer and
easier when done by two people. Cover
or tape any sharp edges on your RV that
could wear against your RV cover. Be sure
to lower any roof antennas.
Tools
Some radio antennas may need to be
unscrewed; usually with a Phillips head
screwdriver. Your cover will fit over flexible
or flat antennas and AC units.
Installation
1.With another person lift the cover to
the roof.
2.Carefully climb up on the roof and take
your cover out of its storage bag (Fig.
1). Place the rolled-up cover at the front
center of the roof and unroll down the
center of the RV toward the back (Fig. 2).
3a. Starting at the front, unfold your
cover from the center outwards. Continue
unfolding the cover as you work toward
the back, letting it fall over the sides of
your RV (Fig. ). Make sure the corners of
the cover are at the corners of your RV.
3b. For travel trailer, 5th wheel and
toy hauler RVs finish by zipping all the
panels closed on your cover then pull
the elasticized corners down over the
bumper(s)
of your RV.
4a. For class A and class C RVs
Your cover is equipped with triple zipper
pulls on the front side panels (Fig. 4).
These extra zipper pulls allow the cover
to fit RVs with mirrors that do not fold
against the RV. Zip all three zipper pulls
down to the mirror height, then zip the
bottom zipper to the bottom of the cover.
Create an opening at the mirror height
by zipping the top zipper up slightly
and the center zipper down slightly. Slip
the opening over the mirror and close
the top and bottom zippers around the
mirror post. Finish by zipping all the
panels closed on your cover then pull
the elasticized corners down over both
bumpers
of your RV.
4b. For 5th wheel RVs
Connect and loosely tighten the tension
panel strap across the bottom front of
the nose of your 5th wheel (Fig. 5). Then
connect the rip-and-grip tabs that fold
in on either side just under the nose of
your 5th wheel (Fig. 6). Adjust and tighten
straps as necessary for a snug fit.
4c. For toy hauler RVs
If your Toy Hauler is a trailer type skip to
step 5. If your Toy Hauler is a 5th wheel
type, Unzip the second zipper from the
front up to the bottom of the overhang on
both sides. Buckle a strap to the upper
tension panel (Fig. 7) (A) on the side of the
overhang and bring it across to the other
side and buckle. Repeat with the lower
tension panels (Fig. 7) (B).
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
A
B
B

5.For all RVs
Included with your cover is a toss bag
to help you attach the straps under your
RV. Before you begin fill your toss bag
with rocks or something of equal weight
equivalent. Clip the toss bag to the buckle
strap attached to the tension panel (Fig
8). Now toss the bag under your RV to
the buckle on the opposite side (Fig 9).
Unclip the strap from the bag and buckle
the bag to the next strap. Repeat with the
remaining straps.
6.Adjust the strap length on the tension
panels across the front and back to fit
your RV. Don’t over tighten—the straps
should be snug, not drum tight.
The sides of your cover can be unzipped
for access to the doors. The panels can
be rolled up and held in place with the
rip-and-grip straps toward the top of each
panel.
Your cover is equipped with extra long
zipper pulls. To secure the zipper pulls so
that they do not drag on the ground bring
the ends of the zipper pulls up and tuck
them into the rip-and-grip closure located
at the base of the zipper along the hem
(Fig. 10).
Use and Storage
A handy storage bag is provided.
The bottom of your bag unzips and
expands to make packing easier.
Note: For easier packing and re-installing
fold and roll tightly before packing in
storage bag.
Never store a wet cover in the storage
bag or confined area as the cover can be
damaged by mildew.
Care
Spot clean with water, a mild soap and
a sponge. Don’t use abrasive cleaners
or brushes.
Fig.10
Fig.8
Fig.9
Instructions PermaPRO™
do not
pack wet
do not iron
line dry
water
resistant
do not
use soap

A. RV Cover
Parts List
Before you begin please check that you have all your parts.
Your package should contain one of the following covers.
description
quantity
Class A
1
Class C
5th Wheel
Travel Trailer
Toy Hauler

A. Storage Bag
Parts List
Your package should contain one of the following storage bags.
part number
description model quantity
PRT-80-001 Medium Bag
Class A
1
Class C
5th Wheel
Travel Trailer
Toy Hauler

A. Toss Bag
Parts List
part number
description
quantity
PRT-80-003
Class A
1
Class C
5th Wheel
Travel Trailer
Toy Hauler
Your package should contain one of the following toss bags.

A. Straps
Parts List
Locate your cover below for the total quantity of straps included.
part number
description
model
quantity
PRT-80-004
Class A
2
3-5
6-8
4
5
6
Class C
1
2-3
4-7
3
4
5
5th Wheel
1
2-3
4-6
3
4
5
Travel Trailer
1
2-4
5-8
3
4
5
Toy Hauler
1-5 7