Clear One COLLABORATE Live 600 User manual

COLLABORATE®Live 600
Quick-Start Guide

COLLABORATE LIVE 600
2
COMPONENTS INCLUDED
COLLABORATE Live 600
COLLABORATE Live 600
codec with power supply
and COLLABORATE
Remote control with
dongle
910-2100-003
UNITE 200 PTZ camera,
power supply, HDMI cable
and RS232 Serial Control
cable
Note: The remote control
inside the camera box
is only for any advanced
configuration in the camera,
if required.
For the camera’s control, use
the COLLABORATE Codec
Appliance’s remote control.
910-156-200-00
CHATAttach 150, cables
and power supply.

QUICK-START GUIDE
3
MAKING THE CONNECTIONS
Connect the CHATAttach 150, the UNITE 200 camera, Ethernet, and
monitor(s) to the COLLABORATE Live 600 codec as shown.
1080p or 720p Digital Display
UNITE 200 Camera Video
Ethernet Connection
Power Connection
Attach Cable
USB Connection
CHATAttach 150
Note: Audio and power connections not shown.
Camera Serial Control

COLLABORATE LIVE 600
4
CONNECTING THE REMOTE CONTROL DONGLE
The Remote Control includes a dongle that plugs into the FRONT USB
port on the codec.

QUICK-START GUIDE
5
AUDIO OUTPUT OPTIONS
There are three audio output options, accessed from the back of the
COLLABORATE Live 600, for connecting the audio.
1. Balanced Audio output to an amplifier that is connected to speakers
2. Line output to powered speakers
3. HDMI output to the primary monitor
Balanced Audio Output
HDMI Combined Video
and Audio Output
Line Audio Output

COLLABORATE LIVE 600
6
CONFIGURING DISPLAY SETTINGS
After all peripherals are connected to the unit, turn the unit on.
Once COLLABORATE Live is loaded – you will see your local camera
video on your screen.
Using the remote control, navigate to the display settings:
Settings > Advanced > Display
According to your monitor capabilities, set to the maximum supported
resolution. If 2 monitors are connected to the unit, the display mode is
automatically changed to dual mode and you can set both monitors’
resolutions.

QUICK-START GUIDE
7
CONFIGURING AUDIO SETTINGS
The COLLABORATE Live 600 audio input is CHAT 150 and audio output
is set to the Balanced Audio Output.
Verify this in COLLABORATE Settings > Audio & Video
Note: It is recommended to use the CHATAttach 150.

COLLABORATE LIVE 600
8
CONFIGURING NETWORK SETTINGS
Using your remote control, navigate into the network settings:
Settings > Advanced > Network
The COLLABORATE Live 600 obtains its IP automatically by default from
the DHCP server.
Set “Obtain Address From DHCP” to “Disabled” to manually configure
network settings.

QUICK-START GUIDE
9
CLEARONE CONTACTS
© 2019 ClearOne, Inc. All rights reserved.
Information in this document is subject to change without notice. QSG-0072-001 Revision 1.0 February 2019
US & Canada
Tel: [phone]
TollFree: 800.945.7730
Fax: [phone]
TechSupport
Tel: [phone]
e-mail: [email protected]
Headquarters
5225 Wiley Post Way
Suite 500
Salt Lake City, UT 84116
Sales
Tel: [phone]
e-mail: [email protected]
International
Tel: [phone]
e-mail: [email protected]
Website
www.clearone.com