Maintenance Instructions ClimaRad Sensa V2X
Upper side Bottom side
20 8.0021
and
press for 6 seconds
Upper side Bottom side
Upper side Bottom side Upper side Bottom side
Slide 3 new
filters in
3 old filters
will slide out
Maintenance frequency for filters
When should you replace the filters?
• vervuildWith normal use, every 2 years or earlier if the message 'Filter ' appears
on the display (for example in homes and offices).
• vervuildIn the case of intensive use, after 1 year or earlier if the message 'Filter '
appears on the display (e.g. for care homes and schools).
Ordering filters
Order new filters at
www.climarad.nl/filters
1. Switch off the device first by
removing the plug from the
socket.
2. Turn the two locking hooks (at
the bottom or on the side of the
housing). Remove the cover of the
Sensa by lifting it upwards.
3. upper and lower slidePush the
on the right side of the ClimaRad
inwards and open both covers by
pulling them towards you.
4. Remove the black filter caps on
the left and right.
5. Slide the three new filters in the
unit from the side. The oldupper
filters will automatically slide out
on the side.bottom
6. Replace the black filter caps on
the upper and bottom side.
8. Put the cover back on and turn
the locking hooks (at the bottom
or on the side of the housing).
7. upperClose the covers on the
and bottom side of the unit, and
slide both latching slides
outwards.
9. Push the plug back into the socket
and reset the filter hour counter (by
simultaneously pressing on the + and
- on the display for 6 seconds ). The
message 'Filter ' willvervuild
disappear. Tighten the locking screws
again.
Important: Reset the filter hour counter only if you have replaced
the filters.
Replacing air supply filters
Future comfort today
