ClimaRad 2.0 User manual

User Instructions Clima ad 2.0R
The ClimaRad ventilation unit optimises the air quality through ventilation and air filtration. The built-in heat
exchanger minimises heat loss. The ClimaRad 2.0 consists of a ventilation unit with a tilting radiator.
The installer will have adjusted the settings of the ClimaRad ventilation unit to the room in which it is installed.
That is why we only explain the function keys you will need for daily use.
You can operate your radiator, as usual, with the radiator button on the side of the radiator. The ClimaRad
ventilation unit is operated with the control panel on top of the radiator.
luchtkwaliteit
snelheid
basisventilatie
filter vervuild
Operation of the ClimaRad ventilation unit
Operating the ClimaRad ventilation unit
Radiator
Heating
Control Panel
AUTO
20 8.0021
Future comfort today

Press 4 seconds simultaneously
Press for 6 seconds
Child lock. This key combination locks your control panel. Press the indicated buttons
simultaneously for 4 seconds. To override this lock you repeat the action.
Function Keys
Automatic control. The ventilation in the room is controlled automatically by your
ClimaRad ventilation unit, which will ventilate the room based on CO measurements.
2
AUTO
Pause. Use this function when you want to temporarily stop the ventilation. After a period
of 4 hours the ClimaRad switches back to automatic control.
Child lock. The child lock is activated.
Maximum ventilation. With this 'boost' function, the ClimaRad increases the ventilation to
the maximum level. Use this function to remove unpleasant odours, such as smoke or
cooking smells. After a period of 4 hours the ClimaRad switches back to automatic control.
Ventilation with cooler outside air. The ClimaRad ventilates with outside air when the
outside temperature is at least 2 degrees colder than the air in the room. After a period of
8 hours the ClimaRad switches back to automatic control. You can set the speed with the +
and - buttons. Use this function, for instance, in summer when at night you want to reduce
the temperature a few degrees in a warmed-up room.
Error. A fault has occurred. Please contact your installer or
housing corporation.
Dirty filter. Replace the air filters or contact your installer or
housing corporation After replacing the filters, press the + and -
buttons for 6 seconds.
You can set your desired ventilation speed with the + and - buttons on your control panel.
After a period of 4 hours the ClimaRad switches back to automatic control.
Messages Switch off
ClimaRad B.V. - Lübeckstraat 25 - 7575 EE - Oldenzaal - NL - [email protected] - www.climarad.co.uk - tel. [phone]
Future comfort today