ClimaRad Care H1C-S User manual

User instructions ClimaRad Care H1C-S
The ClimaRad Care H1C-S device creates the optimum temperature and air quality by heating, cooling, and
ventilating with air filtration and heat reclamation. The built-in heat exchanger ensures that hardly any heat is
lost during ventilation with outside air.
The ClimaRad Care H1C-S in your room is adjusted optimally by the installer and works completely automatically.
This is why we will only explain the function buttons that are relevant for you in daily use.
The control panel is located on the top of the device.
Operating principle ClimaRad Care H1C-S
Operating the ClimaRad Care H1C-S
ClimaRad Care H1C-S
Control panel
2023.001
ClimaRad Care H1C-S

ClimaRad B.V. - Lübeckstraat 25 - 7575 EE - Oldenzaal - NL - [e-mail] - www.climarad.co.uk - tel. [phone]
Press 4 seconds simultaneously
Press for 6 seconds
Child lock. This button combination locks your control panel. Press the indicated buttons
simultaneously for 4 seconds. Repeat this action if you want to unlock the control panel.
Function Keys
Automatic control. The ventilation/heating/cooling in the room is controlled
automatically by your ClimaRad ventilation unit, which works based on CO measurement.
2
AUTO
Pause. Use this function when you temporarily do not wish to ventilate/heat/cool. After a
period of 4 hours your ClimaRad will switch back to automatic control.
Child lock. The child lock is activated.
Maximum. Your ClimaRad will function in the maximum setting. For ventilation, this
function can be used to expel unpleasant odours such as smoke or cooking smells. After a
period of 4 hours your ClimaRad will switch back to automatic control.
Error. A fault has occurred. Please contact your installer or
housing corporation.
Dirty filter. Replace the air filters or contact your installer or
housing corporation After replacing the filters, press the + and -
buttons for 6 seconds.
You can adjust the desired speed for heating or cooling with the + and the – on your
control panel.
Messages Switch off
Ventilation with cooler outside air. Your ClimaRad ventilates with outside air when it is a
minimum of 2 degrees colder than the air in your room. After a period of 8 hours your
ClimaRad will switch back to automatic control. You can control the speed with the + and -
. For example, use this function in the summer when you want to lower the
temperature in your warmed room by several degrees.
Use the AUTO + or AUTO - button combinations to set the desired default temperature of
your room. This will temporarily disable the automatic control. After a period of 4 hours
your ClimaRad will switch back to automatic control.
AUTO
/