ClimaRad Care H1C-C User manual

User instructions ClimaRad Care H1C-C
The ClimaRad Care H1C-C device creates the optimum temperature and air quality by heating, cooling, and
ventilating with air filtration and heat recovery. The built-in heat exchanger ensures that hardly any heat is lost
when ventilating with outside air. A particular feature of this version is its ability to cool below the dew point.
The unit includes a condensate drain.
The ClimaRad Care H1C-C in your room is adjusted optimally by the installer and works completely automatically.
This is why we will only explain the function buttons that are relevant for you in daily use.
The control panel is located on the top of the device.
Operating principle ClimaRad Care H1C-C
Operating the ClimaRad Care H1C-C
ClimaRad Care H1C-C
Control panel
2022.001
ClimaRad Care H1C-C

Press 4 seconds simultaneously
Press for 6 seconds
Child lock. This button combination locks your control panel. Press the indicated buttons
simultaneously for 4 seconds. Repeat this action if you want to unlock the control panel.
Function Keys
Automatic adjustment. The ventilation/heating/cooling in the room is controlled
automatically by your ClimaRad ventilation unit, which functions on the basis of CO
2
measurement.
AUTO
Pause. Use this function when you temporarily do not wish to ventilate/heat/cool. After a
period of 4 hours your ClimaRad ventilation unit will switch back to automatic control.
Child lock. The child lock is activated.
Maximum. Your ClimaRad ventilation unit will function in the maximum setting. For
ventilation, this function can be used to expel unpleasant odours such as smoke or cooking
smells. After a period of 4 hours your ClimaRad switches back to automatic control.
Error. A fault has occurred. Please contact your installer or
housing corporation.
Dirty filter. Replace the air filters or contact your installer or
housing corporation After replacing the filters, press the + and -
buttons for 6 seconds.
You can adjust the desired speed for heating or cooling with the + and the – on your
control panel. After a period of 4 hours your ClimaRad ventilation unit switches back to
the automatic control.
Messages Switch off
ClimaRad B.V. - Lübeckstraat 25 - 7575 EE - Oldenzaal - NL - [e-mail] - www.climarad.co.uk - tel. [phone]
Use the AUTO + or AUTO - button combinations to set the desired default temperature of
your room.
AUTO
Ventilation with cooler outside air. Your ClimaRad ventilation unit ventilates with outside
air when it is a minimum of 2 Degrees colder than the air in your room. After a period of 8
hours your ClimaRad switches back to automatic control. You can control the speed with
the + and -. For example, use this function in the summer when you want to lower the
temperature in your warmed room by several Degrees.
/