Coaster 202095 User manual

REVISION 0 : 11/26/2013
PAGE 1 OF 2
202095
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
CHEST

A.CHEST 1 SET 1SHORT SCREW 1PC
2 LONG SCREW 1PC
3CABLE TIE 1PC
4L BRACKET 2PCS
STEP 2
STEP 1
STEP 3
www.coastercompany.com
PAGE 2 OF 2
ANTI - TIPPING KIT
PARTS IDENTIFICATION HARDWARE IDENTIFICATION
This tip restraint must be attached to a wall stud
using long screw enclosed.
Locate the other bracket on the wall over a wall stud and two
inches below the mounting bracket secured to the back of chest.
Attached to the wall stud using the long screw provided, through
the smaller hole.
Place the chest into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through the larger hole
in each mounting bracket. Bring both ends together and slide the flat end through the locking end and draw it through until all slack is
removed. Confirm that the strap is securely laced and locked.
Attach a bracket securely to the back top rail of the chest using short
screw provided, through the smaller hole.
4
1
WALL
2
4
WALL
3
44