Coaster 203805 User manual

203805
CHEST
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
REVISION 0: 01/12/2015
www.coastercompany.com
PAGE 1 OF 4
REVISION 0: 01/12/2015

ACHEST 1PC
www.coastercompany.com
`
NOTE: PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY
PROCESS. HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
PAGE 2 OF 4
ITEM :
203805 ASSEMBLY INSTRUCTIONS
PARTS IDENTIFICATION
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
!
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2. This product is for home use only and not intended for commercial establishment

ITEM :
203805
ASSEMBLY INSTRUCTIONS
STEP 1
www.coastercompany.com
STEP 2
Complete
www.coastercompany.com
PAGE 3 OF 4
Unscrew drawer pull from the back of drawer front using Phillips head screw driver (NOT INCLUDED).
Align and fasten drawer pull to drawer front using screw and fully tighten with Phillips head screw
driver (NOT INCLUDED).

HARDWARE IDENTIFICATION
ACHEST 1PC 1L- BRACKET 2PCS
2CABLE TIE 1PC
3LONG SCREW 1PC
4SHORT SCREW 1PC
5PLASTIC
ANCHOR 1PC
STEP 3
3.1) Attach one of the mounting brackets securely to the back edge of the chest. Use the short screw.
3.2) Determine where the chest is to be placed and mark location on the wall for the mounting bracket screw
hole approximately 2" below the bracket mounted to the edge of the chest.
3.3) Drill a 3/16" hole in the wall.Press the plastic anchor into the hole and gently tap until the flange on the
anchor is against the wall surface
3.4) Position the bracket and use the long screw to securely attach the bracket to the wall
3.5) Place the chest so the bracket on the back edge is in line with the bracket on the wall.
ANTI - TIPPING KIT
PARTS IDENTIFICATION
3.6) Lace an end of the cable tie down through each bracket. Bring both ends together and slide the beaded
end of the cable tie through the keyhole sha
ped slot on the other end until snug. Pull down on the beaded end
until it snap locks into the keyhole slot.
3.7) To double lock return the beaded end back through the keyhole as shown.
3.8) Check to make sure the cable tie is securely laced and locked to the brackets.
www.coastercompany.com
PAGE 4 OF 4