Coaster 4075B1 User manual

REVISION 0: 06/15/2006
PAGE 1 OF 3
4075B1
FUTON ARM
ASSEMBLY INSTRUCTIONS
www.coastercompany.com
COASTER FINE FURNITURE
REVISION 1: 02/21/2014

ASSEMBLY INSTRUCTIONS
PARTS IDENTIFICATION HARDWARE IDENTIFICATION
A 1
B 2
C 3
D 4
E 5
F 6
G7
H
I
www.coastercompany.com
1PC
LEFT
MECHANISM
ITEM :
4075B1
PLASTIC CAP
SEAT DECK
4PCS
1PC
RIGHT FUTON
ARM
LEFT FUTON
ARM
STRETCHER
1PC
PAGE 2 OF 3
BACK DECK 1PC
HOOK 1PC
WRENCH 1PC
1PC
LONG BOLT
MEDIUM BOLT
SHORT BOLT
HEX NUT
FLAT WASHER
8PCS
4PCS
12PCS
16PCS
8PCS
ALLEN WRENCH
1PC
2PCS
RIGHT
MECHANISM 1PC
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
!Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2. This product is for home use only and not intended for commercial establishment

ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
STEP 3
www.coastercompany.com
3.3) Insert plastic cap to the end of seat deck and back deck (as per diagram shown).
3.4) Align and fasten hook to the center pre-drilled holes of back deck and seat deck (as per diagram shown).
ITEM :
4075B1
PAGE 3 OF 3
1.1) Align and fasten right mechanism to right futon arm
using short bolt & flat washer. Tighten with Allen wrench.
1.2) Align and fasten left mechanism to left futon arm using
short bolt & flat washer. Tighten with Allen wrench.
Align and fasten stretcher to left and right futon arm using long
bolt, flat washer & hex nut (as per diagram shown). Tighten
with both Allen wrench and wrench.
3.1) Align and fasten back deck to left and right mechanism using medium bolt, flat washer and hex nut. Tighten
with both Allen wrench and wrench.
3.2) Align and fasten seat deck to left and right mechanism using medium bolt, flat washer and hex nut. Tighten
with both Allen wrench and wrench.