Cocoon HE160233 User manual

1. Connect each of the camera extension cables to the video and power connectors.
Getting Started Guide
2. Connect the other end of the extension cables to the ports marked “Video IN” on
the back of the DVR.
3. Connect the 8-way power splitter to each of the extension cable power plugs.
4. Connect the included HDMI cable to the back of the DVR and connect the other end
of the HDMI cable to your monitor or TV.
NOTE: You must switch your TV or monitor to the correct INPUT once the DVR has been powered
on. For example, HDMI1
8 CAMERA HOME SECURITY SYSTEM
WITH DVR
HE160233
03/2017

8 CAMERA HOME SECURITY SYSTEM
WITH DVR
After Sales Support 1300 663 907
www.winplus.com.au
6. Connect the power adaptor to the 8-way splitter and plug into an outlet. Switch the
outlet on.
7. Connect the remaining power adaptor to the DVR and plug into a mains outlet.
Switch the outlet on. The DVR will begin the boot sequence.
NOTE: Both the DVR and cameras operate “always on”. To turn the cameras or DVR off, switch off
the power adaptors at the power outlet
Tips: Test all connections are working before permanently installing DVR and cameras.
Position the DVR in a central location where all 8 cameras will reach. If using the optional
networking features make sure the modem is near the DVR
HE160233
03/2017
Getting Started Guide
5. Connect the mouse to the rear USB port.