Commax CDL-800WL User manual

PH M4 X 30 4EA
PH M4 X 6 3EA
FH 4 X 20 4EA
Screw components
Outdoor body
Indoor plate
Indoor body
Assembly Diagram
CDL-800WL EN

ED. 00
1. Install Mortise
PH M4 X 30
Please connect the cables in
line with each color.
<Enlarged view>
6. Install Stricker
5. Connect indoor and
outdoor body
PH M4 X 6
OUT
2. Install handle shaft 3. Position indoor and outdoor body
4. . Connect cable
* Please press button in the order below
if the number plate is shown inside out
after installation.
①[Registration] button in inner side
②[Start] button in outer side
③[Registration] button in inner side
※Setting of direction of handle
Check point
1) Check whether to lock automatically.
- If the door is not normally locked, please check auto-lock setting.
2) Check if Automatic/Manual lock works properly.
3) After registering the fingerprint/smartkey, confirm that the door is open
with the fingerprint/smartkey registered.
4) Explain sufficiently to customers about registration of
Fingerprint/smart key, password change.
5) Check if the door with the password registered is open.
- The password must be registered directly by customer.
6) Explain the internal double lock.
7) Explain battery replacement timing and emergency power supply.
8) Surely, deliver the warranty certificate and instruction manual that you
have written exactly to customer.
Caution
Please insert batteries with the door open at installation.
CDL-800WL EN
FH M4 X 20
Inner side
Outter side
Caution
[When mortise is viewed from above]
(O)
(X)
Inner side
Outter side
Inner side
Outter side