2598380_B_EN_2005_Condair-RE_SIOM 7
Supply line
Supply line
T-fitting valve (not supplied)Saddle valve
Copper tubing with brass sleeve and
brass compression nut.
Plastic hose with brass tubing
reinforcement. Use a plastic sleeve with a
brass compression nut.
IMPORTANT! Do not use the saddle valve to pierce plastic supply water pipes. Only rigid (copper or steel) water
lines can be used with the saddle valve. A T-fitting and shut-off valve must be used with a plastic (or PEX) water
supply line.
IMPORTANT! Ensure pin is completely backed up into the valve body by turning the handle counter-clockwise.
IMPORTANT! Adhere to all local/national plumbing codes.
1. Loosely assemble one side of the top clamp to bottom clap with one screw and nut. For best results, mount
the saddle valve on the top or side of the water supply line.
2. Place gasket over the piercing pin of the top clamp, then place over the water supply line.
3. Assemble the other side of the top and bottom clamps. The water supply line should be between the gasket
and bottom clamp.
4. Tighten the connection between the top and bottom clamps.
5. Connect the water line between the humidifier and saddle valve. Ensure the fittings are installed.
lFor the plastic water line (supplied), from the saddle valve to the humidifier:
a. Place the brass compression nut over one end of the plastic water line. Ensure the wider
opening of the nut faces the saddle valve outlet.
b. Place the plastic sleeve over one end of the plastic water line.
c. Place the brass tubing reinforcement into the plastic water line.
d. Insert the water line into the saddle valve outlet. Push the brass compression nut to the saddle
valve, over the plastic sleeve, and over the brass tubing reinforcement. The fittingsshould be
nested in the nut.
e. Secure the nut to the saddle valve.
f. Connect the other end of the plastic water line to the humidifier, at the inlet valve (or quick
connect, if installed)
6. Twist the handle on the saddle valve clockwise to pierce the water supply line. Twist counter-clockwise to
allow water through the saddle valve.
Gasket
Tapping into an Existing Water Line
You may need to tap into your existing water line to supply water to your humidifier. A saddle valve is supplied
with the unit and will allow you to do this easily. Some installations may require alternative means to divert
your water supply (ex. T-fitting and shutoff valve) and are not supplied with the humidifier. You may require
installation by a licensed plumber. Adhere to all local or regional plumbing codes.
For more information, refer to the Installation Manual.
