Size & Dimension
CAUTION
As this product is not manufactured as safety equipment, make sure to use this product after
mounting double safety device when using it for the purpose of controlling a device having risk
of personal injury, equipment damage or huge property loss.
1. Be well acquainted with way of operation, safety regulations and warnings and make sure to
use the product in accordance with the defined specification and within the related capacity.
2. Do not connect wiring or make installation with the motors or solenoids having big inductive load.
3. In extending the sensor, use the same wire, and do not make it long unnecessarily.
4. Do not use the parts to generate arc in opening and closing at the same or nearby power supply.
5. Power cable should be kept away from high-voltage cable, and should not be installed in the
place of much water, oil or dust.
6. Do not install in the place exposed to direct sunlight or rain.
7. Do not install in the place exposed to strong magnetism, noise, vibration and impact.
8. Keep away from the place where strong alkali or strong acid material is directly discharged.
9. Do not spray water directly for cleaning when installing in the kitchen.
10. Do not install in the place where the temperature and humidity exceed rated range.
11. Use the product not to cut the sensor line or to get flaw on it.
12. Sensor line should be kept away from the signal line, power supply, driving power and load line,
and independent piping should be used for it.
13. This product may not be serviced when disassembled and modified as you like.
14. The mark on the wiring diagram is the safety wording for warning or caution.
15. Do not use near the devices which emit strong high frequency noise (High frequency welder,
High frequency sewing machine, High frequency two-way radio, High capacity SCR controller).
16. If the product is used by the way other than defined by the manufacturer, it may cause personal
injury or property loss.
17. As it is not a toy, keep out of the reach of the children.
18. The installation should be done by an expert or a qualified person.
19. Our company does not assume any responsibility for the damage and loss caused by non
-complying with the above warnings and cautions or through the mistakes of the consumers.
The specification and dimensions provided in the instruction manual is subject to change without
notice for product performance.
Please be familiar with precautions necessary for handling the product.
■Address: Conotec Building, 26 Yunsan-ro
(Bugok-dong), Geumjeong-gu, Busan
Factory: Basement Floor 1
Management Sales Team: 2F
Research Lab and Customer Service: 3F
■Customer Service Phone: +82-51-819-0425-7
(For customer service please send the product
our main office.)
Direct Phone: 070-7815-8266
URL: www.conotec.co.kr
※ The instrument is suitable for the following
environment
Ambient temperature: 0℃-60℃
Ambient humidity: 80%Rh or below
Rater Power: 100-240VAC 50/60Hz
■
Main products & developments
- Digital temp./humi. controller.
- Digital timer, Current/Volt meter
- Development of other product
