Cooper Lighting LINEA Series Installation guide

Important Safety
Instructions—read carefully
for your protection and save
all instructions.
• Do not install any lampholder closer than 6" from any curtain or similar
combustible material.
•CAUTION: To reduce risk of fire and electrical shock, use only
fixtures and fittings intended for use with Linea LV series low voltage
lighting systems.
•CAUTION: This fixture must be used with an isolating type transformer
with an electrical rating not exceeding 24 volts and 25 amps.
Lighted lamp is Hot!
WARNING: To reduce risk of fire or injury;
• Turn off/unplug and allow to cool before replacing lamp.
• Lamps get hot quickly! Contact only switch/plug when turning on.
• Do not touch hot reflector or enclosure.
• Keep lamp away from materials that may burn.
• Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
• This fixture is suitable for use with open or shielded lamps and is
provided with an optional cover glass lens that is to be used for
lamps marked not suitable for open fixture use.
WARNING: To reduce risk of fire or injury read and follow lamp
manufacturer’s instructions for containment requirements and do not
operate fixture with a missing or damaged lens when required.
Installation Instructions for LV303, 304,305, 306, 307, 308, 309 and LV310
702038Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX [phone]
WARNING
Avoid Fire or Electric Shock
• Follow installation instructions carefully.
•If unsure about electrical installation
consult a qualified electrician.
1

7020438Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX [phone]
Installation Instructions for LV303, 304,305, 306, 307, 308, 309 and LV310
2
Outer
Collar
Lampholder Installation
1Make sure power to the channel or wireway
has been turned off.
2Install lamp with proper voltage for
system voltage used.
3Hold lampholder as illustrated and insert
into channel.
4Hold outside collar down while turning
lamp holder 90 degrees to engage channel.
Insert Twist 90°