Costway TY327814 User manual

USER’S MANUAL
Baby Tricycle
TY327814

Please read all instructions carefully and keep it for future reference.
Warnings:
Attention! Use it with protective equipment.
Attention! Not use it in the traffic.
Attention! Applicable Age: 12-50 Months.
General Warnings:
The product must be installed and used under the supervision of an adult.
Read through each step carefully and follow the proper order.
Remove all packaging, separate and count all parts and hardware.
Please ensure that all parts are correctly installed, incorrect installation can lead to a danger.
We recommend that, where possible, all items are assembled near to the area in which they
will be placed in use, to avoid moving the product unnecessarily once assembled.
Ensure a secure surface during construction, und place the product always on a flat, steady
and stable surface.
Please use the product carefully, as the product requires great skill, avoid accidents by the
user or others, by fall or collision.
Please wear suitable protective equipment during use, e.g. protective helmet, gloves, knee
pads, elbow pads etc.
Applicable Age: 12-50 Months
Executive Standard: GB 14747-2006
Warning: This manual contains important information and must be properly
preserved. Non-vehicle, please do not drive on the road. Use it under the care of the
guardian. Educate children about safety before using.
Exploded Drawing And Components List
10.Awning
9.Cup holder
1.Frame
11.Front basket
2.Front wheel assembly
3. Rest pedal
Rest pedal(12-30
months recommended) Sitting pedal(30-50
months recommended)
4.Pedal fixed knob
5.Brake pedal (left + right)
6.Rear wheel assembly
7.Rear storage basket
8.Push rod

1. Unfold the rear wheel frame
Open the rear wheel frame in the direction of the arrow in Figure 1. Take care to ensure that
the rear wheel frame is completely caught in the folding handle.
2. Install the front and rear wheel
As shown in Figure 2, insert the brake pedal 5 into the horizontal tube of the rear wheel
frame, and the rear wheel assembly 6 is inserted into the corresponding hole of the brake
pedal 5 to complete the rear wheel installation (When installing the brake pedal, it is
necessary to distinguish between left and right. When inserting, pay attention to align the
notch position inside the brake pedal with the notch position on the frame).
Insert the front wheel assembly 2 into the hole under the head tube of the frame 1. If it needs
to be disassembled, press the quick release button to remove the front wheel assembly.
3. Install the rest pedal
Insert the rest pedal 3 under the frame 1, align the hole on the pedal with the hole under the
frame, and tighten with the pedal fixing knob 4.
4. Unfold the backrest, armrest and handlebar
Gently pinch the folding handle on the back of the frame 1 to open the seat and adjust it to
the proper position to loosen the folding handle. Pull the knob on the head tube to pull up the
handlebar; just lower the armrest to the free state.
5. Install the awning
As shown in Figure 4, insert the awning sockets on both sides to the corresponding sockets
on both sides of the backrest to complete the awning installation. To disassemble, hold down
the buttons on both sides and pull out.
6. Install the rear push rod
As shown in Figure 5, snap the push rod 8 into the short handle behind the frame 1 to eject
the spring, which means that it is inserted into place, and then snap the cup holder 9 into the
slot on the push rod.
Assembly Diagram
10.Awning
9.Cup holder
1.Frame
11.Front basket
2.Front wheel assembly
3. Rest pedal
4.Pedal fixed knob
5.Brake pedal (left + right)
6.Rear wheel assembly
7.Rear storage basket
8.Push rod
Figure 3 Figure 4
Figure 5 Figure 6
Figure 2
Figure 1

7
www.costway.com
7. Install the rear storage basket
As shown in Figure 6, insert the rear basket 7 along the dotted line to the end.
1. Unfold the sitting pedal
There is a sitting pedal under the frame 1 (Figure 7). Pinch the pull ring on the round tube
and pull down to unfold the pedal from the folded state, and then unfold the pedal tread on
both sides. To close the pedal, simply repeat the above steps in reverse.
2. Seat forward and backward adjustment
(Figure 8) The seat adjustment switch is set on the left side under the seat. You can adjust the
seat back and forth by turning the switch on, and press the switch when the position is
appropriate.
3. Seat rotation adjustment
(Figure 8) There is a seat rotation button at the rear of the seat base. You can adjust the
direction of the seat by pressing and holding the button. There are four optional directions:
front, back, left, and right.
4.Backrest angle adjustment
Adjust the angle of the backrest by pinching the folding handle behind the backrest.
5. Vehicle folding function
a. Folding for travel
Close the awning, flip up the armrests, fold the handlebars to the saddle position and the
backrest to the horizontal position, retract the push rod to the lowest position, press the
spring on the push rod and pull up the sleeve. The push rod is turned forward to the state of
Figure 9, and the awning is folded back to the state of Figure 9, which can be put into the
trunk of most models without disassembling parts.
b. Folding for storage
On the basis of the travel folding steps, then gather the rest pedal, remove the front wheel
assembly, fold the rear wheel assembly, and remove the rear storage basket to make the
whole vehicle smaller and convenient for home storage. (Pay attention to the preservation of
disassembled parts)
Care And Maintenance
1.In order to avoid accidental injury to your baby, please check and maintain the car
frequently.
2.When cleaning the car body, wipe it with a dry cotton cloth.
3.For the rotating parts of the product, such as axles, handlebar rotating shafts, etc., the
lubricants should be added regularly to increase the service life of the product.
4.Check regularly for loose screws and damaged parts. If necessary, repair and replace
damaged parts in time.
5.When disassembling, please follow the instructions carefully to avoid unnecessary
damage.
Instructions for use
Figure 7 Figure 8
Seat adjustment switch
(Front and rear)
Seat rotation button
Figure 9
Folding for travel
Figure 10
Folding for storage

Warning:
1.Please read the manual carefully before installation and use. Keep it properly for future
reference. It will tell you the correct installation procedures and operation methods to avoid
damage to this product or your child due to incorrect operation methods.
2.This product may have potential sharp edges or sharp points or small parts before
assembly, so it must be installed and checked by an adult before use.
3.This vehicle should be used under adult supervision to reduce the risk of injury. Do not use
on highways, close to motor vehicles, near or on slopes, steps, swimming pools or other
bodies of water. Wear shoes, and no more than one rider. Keep away from fire.
4.Do not allow children under 12 months to operate this tricycle.
5.When using this vehicle for the first time, please teach children how to operate it.
6.Before using the car, wear protective equipment and check whether the car is damaged or
not, and whether the parts are connected well to avoid accidents.
7.While this vehicle is driving, please do not let other children approach, and the caregiver
must not leave.
8.Do not let children play with the packaging bag, there is a danger of suffocation.
9.The maximum load capacity of this product is 25 kg, only one baby can ride at a time, and
other babies are strictly prohibited from riding at the same time.
8