Costway TQ10018 User manual

Children’s Ride On Car
TQ10018

Please read all instructions carefully and keep it for future reference.
Warnings:
Attention! Use it with protective equipment.
Attention! Not use it in the traffic.
Attention! The product is not suitable for the children under 3 years.
General Warnings:
The product must be installed and used under the supervision of an adult.
Read through each step carefully and follow the proper order.
Remove all packaging, separate and count all parts and hardware.
Please ensure that all parts are correctly installed, incorrect installation can lead to a danger.
We recommend that, where possible, all items are assembled near to the area in which they
will be placed in use, to avoid moving the product unnecessarily once assembled.
Ensure a secure surface during construction, und place the product always on a flat, steady
and stable surface.
Please use the product carefully, as the product requires great skill, avoid accidents by the
user or others, by fall or collision.
Please wear suitable protective equipment during use, e.g. protective helmet, gloves, knee
pads, elbow pads etc.
02

110 LBS
,
15
03

2.Install motors and wheels.
Please find the drive motor first and disconnect the
drive motor, then insert the motor into the rear axle,
insert the connector wire into the hole and connect
to the power cord. (Please refer to the picture).
04

When this model does not have a front motor, insert washers on both
sides of the front wheel.
rear
（Plug the long part of the line into the steering wheel）
05

4.Install front windshield and back empennage
by screws(M4*12 flat head screw)
by screws（(M4*12 and M4*14 round head screw)
Only here use M4*14
round head screw
06

Please note that the rearview
mirror needs to distinguish
between left and right. Please
insert the rearview mirror into
the window. (referrer to picture)
Lock
Open
First fix the seat with four screws, then install the seat on the
car, paying attention to the buckle joints on the back of the
seat. Put them in the car body. Install the seat and fix the
fasteners in the seat, then rotate 90 degrees to lock it.
07

3-5km/h（For 12V）6-8km/h（For 24V）
57.5” x 36” x 26”
2*12V7AH/4*35W motors
110 lbs.
08

110 LBS.
09

not
10