Courtyard Creations RTS873R User manual

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
PARTS LIST
PAGE 1 OF 3E-2
FIGURE 1
3
4
18
2
COURTYARD CREATIONS INC.
PART
NO. MATERIAL CODE PART Q’TY
1 1
1
1
1
1
1
1
8
10
11
12
13
14
15
16
17
2
3
4
5
6
7
RTS873R-CS03-1
RTS873R-CS02-1
RTS873R-CS01-2
RTS873R-CS01-3
RTS538C-CS01
RTS873R-CS12-1
18000744004
8
17C40A0710001YX
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
Use the correct bolts as indicated. Do not tighten any of the bolts until the swivel rocker chair is completely assembled.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC No. when contacting the service center.
!
!
!
!
!
RTS873R
BOLT M6*30
BACK ASSEMBLY
LEFT ARM
RIGHT ARM
SEAT POST
BASE ASSEMBLY
SEATASSEMBLY
DECORATIVE
PLASTIC COVER
Step 1:
Place the right arm (#4) onto a non-abrasive surface,
such as a carpet. Fasten the back assembly (#1) and
seat assembly (2) to the arms (#3 and #4) by using
bolts (#8). See Figure 1.
4
17C03A0816041YX BOLT M8*45
L
R
Note:
The labels marked “L” and “R” on the arms (#3 and #4)
should coincide with Figure 1 to ensure proper
assembly.
30 #8 BOLT M6*30
9 1
17C40A0712001YX BOLT M6*35
HEX. KEY WRENCH 4MM
WASHER d8.5*D17*1.6
HEX. KEY WRENCH 6MM
1
4
1
2
1
1
17EA1203-----23
17FA05100701-YX
17KAA0101----Y4
17KAA0201----Y4
17FA08060601-YX
17D03A040401-YX
NUT WRENCH 10&13MM
17KAB1101----Y4
JAM NUT M8*1.25
WASHER d6.5*D30*2.0
WASHER
8

45
#10 BOLT M8*45
Note:
For ease with installation, we recommend that the seat
post (#5) be slightly oiled or waxed before fastening to
the base assembly (#6).
E-2
FIGURE 4 FULLASSEMBLY
FIGURE 2 FIGURE 3
PAGE 2 OF 3
Step 2:
Turn the seat assembly to its upright position. Fasten
the seat post (#5) to the seat assembly (#2) by using
bolts (#10), washers (#11 and #13) and jam nuts (#14).
See Figure 2.
Step 3:
Place the decorative plastic cover (#7) onto the chair's
base assembly (#6) as above picture shows.
See Figure 3.
Step 5:
See Full Assembly.
Step 4:
Insert the seat post (#5) into the hole located in the
center of the base assembly (#6). Fasten them together
by using bolt (#9) and washer (#12). Make sure that all
of the bolts have been tightened completely.
See Figure 4.
35
5
6
9
12
#9 BOLT M6*35
52
10
11
13
14
10
11
11
11 13
14
2
5
7
66
A
7A
7
Caution:
To ensure one’s safety during use of this swivel rocker
chair, examine all of the bolts to make sure that they
are securely fastened. This is a chair with swivel rocker
ability; therefore, use by young children should be adult
supervised.

E-2 PAGE 3 OF 3
Cleaning and Maintenance
•Wash frame and fabric parts with mild soap and water, rinse thoroughly, and dry completely. Do not
use bleach, acid, or other solvents on the frame or fabric parts.
•We recommend the use of furniture covers when not in use.
•Inspect and tighten all bolts and fasteners on a regular basis to ensure the proper performance and
safety of your swivel rocker chair.
•In order to prolong the life and beauty of your swivel rocker chair, we recommend that it be stored in
a dry and protected area during off season periods.
Warranty
•This product is covered by Courtyard Creations Inc.'s one–year limited warranty.
•Proof of purchase (dated register receipt) is required for warranty claims.
•It remains the customer’s responsibility for freight and packing charges to and from the service center.
The store where you made your purchase
does not stock parts for this item.
If you need parts,
whether they are missing or damaged,
STOP!
MissingA Part?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
For further assistance,
please visit us at
[email protected]
Call Toll Free:
TEL: [phone]
FAX: [phone]
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
SEPARATE AND IDENTIFY ALL OF THE PARTS,MAKING SURE THAT
YOUHAVE ALL OF THEPARTSLISTED.
IF YOU DO NOTLOCATE ALL OF THE PARTS LISTED, INSPECT THE
PACKING MATERIAL FOR SMALL PARTSTHAT MAYHAVEBECOME
SEPARATED DURING SHIPMENT.
IF YOU EXPERIENCEANY DIFFICULTYDURING ASSEMBLYOR IF ANY
PARTS ARE MISSING OR DAMAGED,CALL THE HELP LINE AT
1-877-539-7436 BEFORERETURNING THIS ITEM TO THESTORE.
PROVIDE THEFOLLOWING INFORMATION WHEN CALLING:
1-MODEL NUMBER OF THEPRODUCT.
2-PARTNUMBER AND MATERIAL CODE OF THE PARTFROM THE PARTS
LIST.
MOST PROBLEMSCAN BERESOLVED WITHOUT RETURNING THIS
PRODUCT TO THERETAILER.