Courtyard Creations TCS67SD User manual

25 #8 BOLT M6*25
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
Note:
The tiles are easy to be broken, be careful when you remove
them.
Step 1:
Place the table top (#1) onto a non-abrasive surface, such as
a carpet, with its underside facing upwards. Fasten the legs
(#2) and the supports (#3) to the underside of the table top
(#1) rim by using bolts (#8). Keep the bolts loose.
See Figure 1.
FIGURE 1
1
3
3
22
2
2
8
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
Attention:
Make sure that each bolt needed for all steps matches the
corresponding figure to ensure proper assembly.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
!
!
PAGE 1 OF 2 COURTYARD CREATIONS INC.
HEX.KEY WRENCH 4MM
BOLT M6*25
BOLT M6*15
LEG
SUPPORT
TABLE TOP
TCS67SD
PARTS LIST
PART
NO. MATERIAL CODE PART Q’TY
1
2
3
4 1
2
4
1 7
8
9
10
11
8
8
TCS67SD-CS05-1
TCS67SD-CS04-1
TCS67SD-CS04-2
17KAA0101----Y4
CENTER
CONNECTOR WITH RING 1
17C40A0709001YX
17C40A0705001YX
62TGS66PAY101
1
HEX. KEY WRENCH 10MM
17KAC3101----Y3
TILE B 600*148.5*10 66 13C??2CF100A001
TILE C 149.5*149.5*10 4
13C??1B3000A001
TILE A 600*600*10 25 13C??1B0200A001
E-2

E-2
Step 2:
Fasten the center connector with ring (#4) to the middle of the
legs (#2) by using bolts (#9). Keep the bolts loose.
See Figure 2.
Step 3:
Fasten the center connector with ring (#4) to the middle of the
supports (#3) by using bolts (#8). Make sure that all of the bolts
have been tightened completely. See Figure 3.
Step 4:
Turn the table to its upright position. Then put the tiles (#5, #6 and #7) onto the table top (#1) carefully. See Figure 4 and Figure 5.
Note:
1. If any EVAfoams on the table top are missing, there are extra EVA foams in the hardware kit. See Illustration A.
2. To use an umbrella with this table, put the umbrella pole through the table top and center connector ring.
FIGURE 3FIGURE 2
FIGURE 5FIGURE 4
43
3
A
22
2
4
2
Cleaning and Maintenance
•Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach, acid, or other solvents
on the frame parts.
•Inspect and tighten all bolts and fasteners on a regular basis to ensure the proper performance and safety of your table.
•When moving the table, remove the umbrella and lift. Do not drag this table.
•We recommend the use of furniture covers when not in use.
•In order to prolong the life and beauty of your table, we recommend that it be stored in a dry and protected area during off
season periods.
•The umbrella should be lowered and/or removed in windy conditions.
8
6
5
7
1
9
9
25
#8 BOLT M6*25
15
#9 BOLT M6*15
PAGE 2 OF 2
Warranty
• This product is covered by Courtyard Creations Inc.'s one–year limited warranty.
• Proof of purchase (dated register receipt) is required for warranty claims.
• It remains the customer’s responsibility for freight and packing charges to and from the service center.
The store where you made your purchase
does not stock parts for this item.
If you need parts,
whether they are missing or damaged,
STOP!
MissingAPart?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
For further assistance,
please visit us at
[email protected]
Call Toll Free:
TEL: [phone]
FAX: [phone]
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
SEPARATE AND IDENTIFY ALL OF THE PARTS,MAKING SURE THAT
YOUHAVE ALL OF THEPARTSLISTED.
IF YOU DO NOTLOCATE ALL OF THE PARTS LISTED, INSPECT THE
PACKING MATERIAL FOR SMALL PARTSTHAT MAYHAVEBECOME
SEPARATED DURING SHIPMENT.
IF YOU EXPERIENCEANY DIFFICULTYDURING ASSEMBLYOR IF ANY
PARTS ARE MISSING OR DAMAGED,CALL THE HELP LINE AT
1-877-539-7436 BEFORERETURNING THIS ITEM TO THESTORE.
PROVIDE THEFOLLOWING INFORMATION WHEN CALLING:
1-MODEL NUMBER OF THEPRODUCT.
2-PARTNUMBER AND MATERIAL CODE OF THE PARTFROM THE PARTS
LIST.
MOST PROBLEMS CAN BERESOLVED WITHOUT RETURNING THIS
PRODUCT TO THERETAILER.