Courtyard Creations TCS73SC User manual

TCS73SC
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
ASSEMBLY INSTRUCTIONS
HEX. KEY WRENCH 4MM
BOLT M6*25
PARTS LIST
PART
NO.
1
2
3
4
4
4
2
1
8
9
10
11
12
1
1
2
14
7
5
TCS73SC-CS05-1
TCS73SC-CS04-2
TCS73SC-CS04-1
62TCS73SCY101
13C??7B29008001
2
2
2
3
3
2
1
8
17KAA0101----Y4
TABLE TOP
SUPPORT
LEG
CENTER
CONNECTOR WITH RING
TILE A
6
13C??1B29008001
TILE C
1
MATERIAL CODE PART Q’TY PART
NO. MATERIAL CODE PART Q’TY
#8 BOLT M6*15
Note:
The tiles can be easily broken, be careful when you remove
them.
PAGE 1 OF 2 COURTYARD CREATIONS INC.
Attention:
Make sure that each bolt needed for all steps matches the
corresponding figure to ensure proper assembly.
Step 1:
Place the table top (#1) onto a non-abrasive surface, such
as a carpet, with its underside facing upwards. Fasten the
legs (#2) and the supports (#3) to the underside of the table
top (#1) rim by using bolts (#8). Keep the bolts loose.
See Figure 1.
FIGURE 1
BOLT M6*15
17C40A0705001YX
17C40A0709001YX
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC No. when contacting the service center.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
!
!
!
!
!
!
!
15
HEX. KEY WRENCH 10MM
17KAC3101----Y3
E-3
6 12
13C??BCEP008001
TILE B TOUCH-UP PAINT
1422 1

PAGE 2 OF 2
E-3
Step 2:
Fasten the center connector with ring (#4) to the middle of the
legs (#2) by using bolts (#8). Keep the bolts loose.
See Figure 2.
Step 3:
Fasten the center connector with ring (#4) to the middle of the
supports (#3) by using bolts (#9). Make sure that all of the
bolts have been tightened completely. See Figure 3.
Step 4:
Turn the table to its upright position. Then, carefully put the tiles (#5, #6, and #7) onto the table top (#1). See Figure 4 and
Figure 5.
FIGURE 3FIGURE 2
FIGURE 5FIGURE 4
4
3
3
A
22
2
4
2
2515
#9 BOLT M6*25
#8 BOLT M6*15
567
1
Cleaning and Maintenance
•Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach, acid, or other solvents
on the frame parts.
•
Inspect and tighten all of the bolts and fasteners on a regular basis to ensure the proper performance and safety of your table.
•When moving the table, remove the umbrella and lift. Do not drag this table.
•We recommend the use of furniture covers when not in use.
•In order to prolong the life and beauty of your table, we recommend that it be stored in a dry and protected area during off
season periods.
•The umbrella should be lowered and/or removed in windy conditions.
9
8
8
Note:
1. If any EVA foams on the table top are missing, there are extra EVA foams in the hardware kit. See Illustration A.
2. To use an umbrella with this table, remove the center plug and put the umbrella pole through the table top and center
connector ring.
3. To repair any scratches on the frame, use the touch-up paint (#12) provided.
The store where you made your purchase
does not stock parts for this item.
If you need parts,
whether they are missing or damaged,
STOP!
MissingAPart?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
For further assistance,
please visit us at
[email protected]
Call Toll Free:
TEL: [phone]
FAX: [phone]
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
SEPARATE AND IDENTIFY ALL OF THE PARTS,MAKING SURE THAT
YOUHAVE ALL OF THEPARTSLISTED.
IF YOU DO NOTLOCATE ALL OF THE PARTS LISTED, INSPECT THE
PACKING MATERIAL FOR SMALL PARTSTHAT MAYHAVEBECOME
SEPARATED DURING SHIPMENT.
IF YOU EXPERIENCEANYDIFFICULTYDURING ASSEMBLYOR IF ANY
PARTS ARE MISSING OR DAMAGED,CALL THE HELP LINE AT
1-877-539-7436 BEFORERETURNING THIS ITEM TO THE STORE.
PROVIDE THEFOLLOWING INFORMATION WHEN CALLING:
1-MODEL NUMBER OF THEPRODUCT.
2-PARTNUMBER AND MATERIAL CODE OF THE PARTFROM THE PARTS
LIST.
MOST PROBLEMSCAN BERESOLVED WITHOUT RETURNING THIS
PRODUCT TO THERETAILER.
Warranty
•This product is covered by
Courtyard Creations Inc.'s
one–year limited warranty.
•Proof of purchase (dated
register receipt) is required
for warranty claims.
•It remains the customer’s
responsibility for freight and
packing charges to and from
the service center.