Creality Ender-6 User manual

V1.2

≤180mm/s,Normal|正常为 60mm/s

30

Notes: If the T-type screw is inclined, please
slightly loosen the 4 screws on the Z-axis
motor and make the screw rod vertical
through moving the T-nut connector to, and
then tighten the screws on the motor.
注意：如果T型丝杆有倾斜现象，请稍微松开Z轴
电机的4个固定螺丝，并用手上下移动T型螺母
连接件，使丝杆趋于垂直，然后再锁紧电机固定
螺钉。

The rubber pad at the bottom of machine will be slightly deformed under stress.
If this happens when you install the acrylic plate, please loosen the foot pad first, and then lock them after installing the acrylic board.
由于底部橡胶垫在受力情况下会有微小变形，安装亚克力板时如出现和橡胶垫陷入部分干涉，可先将脚垫微松，安装完亚克力板后再锁紧脚垫。
10

Loosen the screws at A and B in the figure, and press the
corrugated tube into the hold-down block to prevent
them from hanging down on the Hotbed.
将图示A、B两处的螺丝拧松，将波纹管压在压紧块内，以便防
止线材垂于热床板上。
B
A

After installation, to ensure each V-wheel is well combined with the
profile. Please check as follows before printing.
1. Z-axis: Check whether the 8 pieces of V wheels is idling;
2. X-axis: Check whether the 4 pieces of V wheels on the nozzle
mounting plate are idling;
3. Y-axis: Check whether the 4 pieces of V wheels on the left and right
sides of the mounting plate are idling;
If there is idling, please adjust the eccentric nut.
安装完后为确保各V轮与型材良好接触，在打印前请进行如下检查：
1、Z轴：用手轻转8个V轮检查是否有空转情况；
2、X轴：检查喷嘴安装板的4个V轮是否有空转情况；
3、Y轴：检查左右两侧安装板的4个V轮是否有空转情况；
如有空转，请通过调节偏心螺母使每个V轮在用手轻转时均不出现
空转。