Cres Cor H135SUA6A Manual

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 1 of 7
Model No. Volts Watts Amps Hertz Phase NEMA
H135SUA6A
H135SUA11A 120 1500 12.3 60 1 5-15P
H135SUA6A240
H135SUA11A240 240 1500 6.1 60 1 6-15P
The above are base model numbers. Other characters may be present.
HOW TO INSTALL UNIT:
1. Place cabinet near warm ovens if possible. For
best results, do NOT put in drafty areas or near
ventilating systems.
2. Plug cord end into proper wall outlet.
HOW TO START UNIT:
1. Turn thermostat to #10.
2. Preheat cabinet for 30 minutes.
3. Put food into cabinet.
4. Turn thermostat to #8 and close door.
NOTE: No. 9 setting = approx. 190°F (88°C)
No. 7 setting = approx. 165°F (74°C)
Proper food holding temperature is 140°F (60°C) or
higher. The thermometer shows the temperature inside.
TO TURN OFF UNIT:
1. Turn thermostat o.
2. Turn the POWER switch o.
1 2
3 4
1. RED LIGHT - POWER
2. SWITCH - POWER
3. THERMOSTAT - AIR
4. THERMOMETER

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 2 of 7
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE
PERSONNEL ONLY
RISK OF FIRE OR ELECTRIC SHOCK
DO NOT OPEN
WARNING
HOW TO CLEAN UNIT:
Soil Cleaner Method
DOORS
Stainless Steel Dirt, Grease and Oil Mild Detergent* and water.
1. Wipe with soft, damp cloth.
2. Rinse well.
CABINETS
Stainless Steel
Dirt
Mild detergent* and hot
water, or mild abrasive
cleaner.
1. Use soft, damp cloth.
2. Rinse with hot water.
3. Wipe dry.
Steam (No strong alkaline
additive)
1. Rinse after steam cleaning.
2. Wipe dry.
Fingerprints, Grease
and Oil
Chemical oven cleaner
for cabinet material Follow oven manufacturer’s directions
Mild abrasive cleaner; oily
or waxy cleaner
Apply with clean, soft cloth. Wipe with
damp cloth.
Water Spots Mild abrasive cleaner.
Oily of waxy cleaner.
Apply with soft, clean cloth.
Wipe with damp cloth.
Cleaning Notes:
1. Wipe up spills as soon as possible.
2. Clean cabinet regularly to avoid heavy dirt build-up.
3. Make a test spot with cleaner.
4. Follow manufacturer’s directions on cleaner.
5. Do not mix cleaners.
6. Avoid drips and splashes.
1. Allow cabinet to cool.
2. Do NOT use abrasives or harsh
chemicals.
HOW TO CLEAN THE CABINET:
WARNING BEFORE cleaning
the cabinet:

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 3 of 7
TROUBLE-SHOOTING CHART:
FAILURE POSSIBLE CAUSE
1. Red light at switch does NOT light. 1a. Switch is “OFF”.
1b. Cord is unplugged from wall outlet.
1c. Circuit breaker/fuse to wall outlet is blown.
2. Unit does not heat. 2a. Thermostat set too low or is “OFF”.
2b. Switch is “OFF”.
2c. Defective electrical parts.
3. Unit gets too hot or won’t shut o. 3a. Defective electrical parts. UNPLUG UNIT FROM
WALL OUTLET.
4. Blower does not work or makes noise. 4a. Defective blower.
NOTE: Optional digital thermometer will ash if cabinet temperature is below 140° F or above 250° F.
Call the factory if you need dierent settings.
If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400.

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 4 of 7
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
HOW TO REVERSE DOOR SWING FOR
OPPOSITE HAND:
1. Remove hinge covers with a screwdriver.
2. Open door and lift up to remove door from
cabinet.
3. Unscrew and re-mount the hinges and latch strike
to the opposite sides of the cabinet.
4. Remove the door hinges and magnets.
5. Move extra screws to opposite end of hole
patterns.
6. Mount hinges and magnets. Make sure hinges are
mounted post down.
7. Put door onto cabinet and adjust as necessary.
8. Snap on hinge covers.
Right Hand
Left Hand

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 5 of 7
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11 & H135SUA6 Hot Cabinets
4
7
CABINET PARTS
PART NO. DESCRIPTION ITEM
0567-697 WASHER, 1.500 1
0567-822 SHOULDER SCREW, 10-24 2
0806-011 CLAMP - CABLE, 1/4" DIA. 3
0810-029-06 CORD SET 15A, 125V 12.5"LG 4
0818-057 STRAIN RELIEF BUSHING 5
0852-091 TERMINAL BLOCK 6
0911-087 HANDLE 7
1202-013 BUSHING 2" 8
5032-024 HEAT SHIELD 9
5258-010 CORD CLIP 10
5361-014 PANEL, VENT 11
MISC PARTS
PART DESCRIPTION
0569-306 CASTER, 5"
0569-306-B CASTER, 5",
1221-684 DOOR, WINDOW*
*FOR RED DOORS ADD -R
1
2
REPLACEMENT PARTS: CABINET

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 6 of 7
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11 & H135SUA6 Hot Cabinets
1
2
3
4
5
6
CONTROL PANEL PARTS
PART NO. DESCRIPTION ITEM
0595 061 KNOB 1
0750-021 CONTROL PANEL, FACE 2
0848-062 THERMOSTAT 3
1115-661 LABEL, H135 A SERIES 4
5238-030 THERMOMETER - ANALOG 5
6537-402 CONTROL PANEL 6
1
2
3
4
6
7
SOLID DOOR PARTS
PART NO. DESCRIPTION ITEM
0685-512 DOOR, OUTER 1
0686-274-SS DOOR, INNER 2
0861-271 GASKET, DOOR 3
0911-129 PULL HANDLE 4
1228-379 INSULATION 5
1447-031 MAGNET 6
1466-693 REINFORCMENT, DOOR 7
*FOR RED DOORS ADD -R
*
REPLACEMENT PARTS: CABINET

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 7 of 7
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11 & H135SUA6 Hot Cabinets
1
2
4
5
6
12
13
14
3
HOT UNIT PARTS
PART NO. DESCRIPTION ITEM
0553-934 COVER, BLOWER 1
0553-935 COVER, HEATER BOX 2
0769-180 BLOWER ASSY, 120V 3
0811-285-01 HEATER 750W/120V 4
1202-008 GROMMET 5
1202-016 GROMMET, HI TEMP SILICONE 6
1228-473 INSUALTION, HEATER 7
1228-475 INSUALTION, BLOWER 8
1228-477 INSULATION, HEAT SHIELD 9
1228-478 INSULATION, BOTTOM 10
1228-480 INSULATION, BLOWER 11
1410-032 BRKT, HEATERS 12
5032-023 SHROUD, BLOWER 13
5032-025 DIFFUSER 14
1
2
3
4
5
6
7
SWITCH PLATE PARTS
PART NO. DESCRIPTION ITEM
0766-101 LIGHT, RED, 120VAC 1
0807-173 TERMINAL, QC 2
0808-131 SWITCH, ROCKER, 3
0817-014 LEVERNUT, WIRE - 3 POLE 4
0817-015 LEVERNUT, WIRE - 5 POLE 5
0988-022 COVER, SWITCH 6
1115-662 COVER, SWITCH 7
REPLACEMENT PARTS: HOT UNIT

5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 8 of 7
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11A & H135SUA6A Hot Cabinets (Stainless Steel)
5925 Heisley Road • Mentor, OH 44060-1833
Hot Cabinets FL-2408
Rev. 0 (1/19) Page 8 of 7
6-15P
POWER SWITCH
POWER ON LED
<
G
<
<
G
5-15P
<>
<
W
L1
N
G
N
L1
BLOWER
M
78
7
B
1
24
8
B
W
W
12
4
HOT AIR THERMOSTAT
TOP AIR HEATER
BOTTOM AIR HEATER
14 14
9,10
12,13
13 10
12
9
R
4321
5
7
8
°t
12VAC
TRANSFORMER
FOR 120VAC
INPUT
DIGITAL
THERMOMETER
SENSOR
4321
5
7
8
°t
12VAC
TRANSFORMER
FOR 220VAC
INPUT
DIGITAL
THERMOMETER
SENSOR
50
51 52
51 50
OPTIONAL
WIRE KIT: 5812-918
50 51
NOTES: 1. REFERENCE WIRE KITS 5813-044 (HALF SIZE) & 5813-045 (FULL SIZE)
G
N
L1
W
BG
3
TB2
TB1
REAR VIEW OF POWER SWITCH SHOWN (SWITCH PLATE FLIPPED DOWN)
OPERATING and MAINTENANCE INSTRUCTIONS
H135SUA11 & H135SUA6 Hot Cabinets
51
50
4
OPTIONAL
TB2
B
8
12
9
10
2
50
51 52
W
4
7
78
R
50
51
4321
5
7
8
<
2
B
WIRE KIT: 5812-918
3
G
G
<
°t
TB1
POWER ON
LED
POWER
SWITCH
12VAC
TRANSFORMER
FOR 120VAC
INPUT
BOTTOM AIR HEATER
TOP AIR HEATER
W
13
12,13 SENSOR
G
°t
DIGITAL
THERMOMETER
BLOWER
4321
5
7
8
N
L1
L1
12VAC
TRANSFORMER
FOR 220VAC
INPUT
N
>
9,10
14
DIGITAL
THERMOMETER
W
1
M
HOT AIR
THERMOSTAT
1
SENSOR
14
<
<
<
G
B
W
L1
NG
WIRING DIAGRAM: