GB/IE/NI GB/IE/NIGB/IE/NIGB/IE/NI
GB/IE/NI GB/IE/NI GB/IE/NIGB/IE/NI GB/IE/NIGB/IE/NI
or damage to fragile parts, e.g. switches, rechargeable
batteries, or made from glass. This warranty becomes
void if the device has been damaged or improperly
used or maintained. Proper use of the product requires
strictly observing all instructions for use. Purposes and
practices which the operating instructions warn of or
advise against must be avoided without fail. This prod-
uct is only intended for private, non-commercial use.
Any incorrect or improper use of the device, use of
force and changes not performed by our authorized
service branch will void the warranty.
Please follow the instructions below to ensure your
claim is processed quickly:
· Please have your receipt and the product num-
ber ready as your proof of purchase.
· Please refer to the type plate or the cover sheet
of these instructions for the product number.
· In the event of malfunctions or other defects,
please first contact the following service depart-
ment by phone or e-mail.
· A product determined defective may then be
returned to the specified service address free of
charge, including the proof of purchase (receipt)
and information about the defect and when it
occurred. Please note, the service department
must be notified before returning the product!
This and many other manuals, product videos and
software are available for download at
www.lidl-service.com.
GB
KLB GmbH
Diekbree 8
DE-48157 Münster, GERMANY
Phone: +49 2 51 132 37 57
email: gb@klb-service.eu
www.klb-service.eu
Improper rechargeable battery disposal destroys val-
uable resources and the hazardous substances in the
rechargeable batteries may pose a significant danger
to human health and environment. Separate collection/
disposal of old rechargeable batteries prevents dan-
gers to human health and environment, and valuable
resources regained by recycling.
Warranty
Dear customer,
This device is covered by a 3-year warranty from the
date of purchase. In the event of product defects, you
have legal rights against the retailer of this product.
Your statutory rights are not limited in any way by our
warranty detailed below.
Warranty terms
The warranty period begins on the date of purchase.
Please retain the original receipt safely. This documen-
tation is required as the proof of purchase. Should a
defect in material or manufacture occur within three
years from the date of purchase of this product, we
will repair or replace - at our choice - it free of charge.
This warranty is conditional on the defective device
and the receipt of purchase being presented within
the three year warranty period, and that there is a
brief written description of the nature of the defect
and of the date it arose. If the defect is covered by
our warranty, you will receive the repaired product
or a replacement. A repair or exchange of the device
does not extend a new warranty period. The warranty
period will not be extended by repairs made under
warranty. This also applies to replaced and repaired
parts. Any damage or defects present at the time of
purchase must be reported immediately after unpack-
ing. Repairs made after the expiration of the warranty
period are subject to payment.
Extent of warranty
The device was manufactured to strict quality guide-
lines and diligently inspected prior to shipment. The
warranty applies to defects in material or manufacture.
This warranty does not apply to product parts subject
to regular wear and therefore considered wear parts
headlight (recommended charging time for the
tail light is 2.5 hours).
Cleaning and care
Never fully immerse the lights. Do not use corro-
sive or abrasive cleaning agents. Doing so will
damage the lights.
C
lean the LED bicycle light set with a slightly da
mp,
lint-free cloth.
Disposal
The packaging is made of environmentally
friendly materials, which may be disposed
of through your local recycling facilities.
Contact your local refuse disposal authority for more
details on how to dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly, not with-
out household waste, when it has reached
the end of its useful life. Please contact your
local authority for information on collection
points and their opening hours.
Defective or old rechargeable batteries must be recy-
cled in accordance with Directive 2006/66/EC and
its amendments. Return rechargeable batteries and/
or the device to the recycling facilities provided.
Improper disposal of rechargea
ble
batteries may result in environ-
mental damage!
Rechargeable batteries may not be disposed with
household waste. They may contain toxic heavy met-
als and are subject to hazardous waste regulations.
The chemical symbols of the heavy metals are: Cd =
cadmium, Hg = mercury, Pb = lead. For this reason,
dispose of used rechargeable batteries at a local
collection point.
Operation
Switching on/off
The headlight 6has three brightnesses.
On/ Off switch
press once Automatic mode: The light inten-
sity adapts automatically to am-
bient lighting conditions. When
automatic mode is switched on
5the switch flashes green.
press twice Power mode (50 Lux) for riding
in unlit areas
press three
times
Standard mode (25 Lux) for
riding in lit areas
press four times Eco mode (10 Lux) for riding in
well lit areas
press five times off
Charging the headlight/tail
light (see Fig. D+E)
Remove the rubber cover from the battery charg-
ing socket 17 and connect the USB cable 16 to
the battery charging socket 17 .
Then connect the USB plug of the USB cable 16
to a computer/ laptop / standard USB charger
with 5V DC and 500–1000 mA. Using chargers
with different specifications can damage the re-
chargeable battery, thus the headlight. Doing so
will void the warranty.
The headlight 6and tail light 14 feature a bat-
tery indicator. If the indicator lights up red, the re-
chargeable batteries are drained. The indicator
will light up green whilst charging. When the re-
chargeable batteries are ready to be used again,
the indicator will go out and you can use the
headlight 6and tail light 14 .
For the built-in rechargeable battery to operate
at full power, please do not charge the headlight
rechargeable battery for less than 6 hours the
first time (tail light: no less than 5 hours). Please
do not stop charging sooner, even if the LED is
already extinguished. After this, a charging time
of approx. 3.5 hours is recommended for the
Installation
Installing the headlight
(see Fig. A)
Unscrew the retaining screw 3from the
bracket 1.
Position the bracket 1in the desired location
on the handlebar. If necessary, use the reducer
rubbers 2to ensure an optimal fit.
Reinstall the retaining screw 3.
Tighten the screw hand tight. To prevent damage,
do not use tools for this step.
To adjust to the optimal angle to the direction of
travel, loosen the angle adjustment screw 7
2–3 turns using a cross-tip screwdriver.
Adjust to the desired angle and tighten the angle
adjustment screw 7.
Slide the headlight 6into the bracket 1until
you hear it lock into place.
To release, press the headlight lock 8and slide
the headlight 6forward out of the bracket 1.
ATTENTION!Routinely verify the headlamp ad-
justment. The light cone must point straight ahead,
in the direction of travel, and must not be adjusted
too high so as not to blind oncoming traffic.
Installing the tail light
(see Fig. B and C)
Secure the bracket 9to the seat post or the rear
cross-bar using the rubber tab 11 . Be sure there
are no objects in front of the tail light 14 .
Tighten and hook in the rubber tab 11 .
Loosen the retaining screw 15 on the bracket 9
and adjust to the desired angle.
Then tighten the screw. Tighten the screw hand
tight. To prevent damage, do not use tools for
this step.
Slide the tail light 14 into the bracket 9until you
hear it lock into place.
To remove the tail light 14 press the tail light
locking mechanism
10
and take off the tail light
14
.
ATTENTION! The tail lamp must be installed
and adjusted so the reference axis is parallel to
the median longitudinal plane of the vehicle and
parallel to the road.
Never take the product apart. Improper re-
pairs may result in considerable danger to
the user. Repairs should only be carried out
by specialist personnel. The LED lights are
not replaceable.
RISK OF LOSS OF LIFE
AND ACCIDENT! Using the incorrect
charger may cause the headlight 6and
the tail light 14 to be damaged, overheat
or even explode. Doing so will void the
warranty.
Safety instructions for
rechargeable batteries
CAUTION! EXPLOSION
HAZARD! Keep rechargeable
batteries away from children, do
not throw rechargeable batteries into fire,
do not short-circuit and do not take apart.
Failure to observe this instruction may result
in the rechargeable batteries discharging
beyond their end voltage. This poses a risk
of leaking.
Avoid contact with the skin, eyes and muc
ous
membranes if fluid has leaked from the re-
chargeable batteries. In the event of contact
with battery acid, thoroughly flush the af-
fected area with clean water and seek im-
mediate medical attention.
Note: If the red rechargeable battery con-
trol light 5, 13 on the headlight 6or the
tail light 14 lights up,please recharge the
rechargeable batteries immediately.
Please note, once the rechargeable battery
control system lights up, the lights no longer
comply with the Road Traffic Act.
Technical data
Headlight (auto-dimming)
Model designation: L1-2A / XC-195S
Rated output: 1W
Protection type: IP44 according to
DIN EN 60529
Rechargeable
Li-ion battery: 1300 mAh, 3.7 V
Tail light
Model designation: LR-1 /XC-242
Rated output: 0.2W
Protection type: IP44 according to
DIN EN 60529
Rechargeable
Li-ion battery: 300 mAh, 3,7 V
Safety instructions
DANGER TO
LIFE AND RISK OF ACCIDENT
FOR INFANTS AND CHILDREN!
Never leave children unsupervised with the
packing material due to the suffocation haz-
ard posed by swallowing parts thereof. Chil-
dren frequently underestimate the dangers.
Always keep the product away from chil
dren.
This product is not a toy!
T
his product may be used by children 8 yea
rs
and up as well as by persons with physical,
s
ensory or mental impairments or lacking e
x-
perience and knowledge, when supervised
or instructed in the safe use of the product
and understand the associated risks. Do
not allow children to play with the product.
Cleaning and user maintenance must not be
performed by children without supervision.
Please note, damages caused by incorrect
handling, non-compliance with the operating
instructions or interference with the device
by unauthorised individuals are excluded.
the product on to anyone else, please be sure to also
include all documentation.
Intended use
This product is suitable for lighting the roadway whilst
cycling. The LED Bicycle Light Set is approved as ex-
clusive lighting for all bicycles. Light distribution must
not be impaired by other bicycle parts or luggage.
The product is intended for outdoor use. Any use other
than the aforementioned or any product modification
is prohibited and can result in injuries and product
damage. The manufacturer is not liable for damages
r
esulting from improper use. This product is not inte
nded
for commercial use.
Parts description
1Headlight bracket
2Reducer rubber
3Headlight bracket retaining screw
4Headlight on/ off switch
5Headlight rechargeable battery control system
with integrated automatic mode indicator
6Headlight
7Headlight angle adjustment screw
8Headlight lock
9Tail light bracket
10 Tail light lock
11 Tail light bracket rubber tab
12 Tail light on/ off switch
13 Tail light rechargeable battery control system
14 Tail light
15 Tail light retaining screw
16 USB cable
17 Rechargeable battery charging socket (front
and rear lights)
Scope of delivery
1 Headlight
1 Tail light
1 Headlight bracket
1 Tail light bracket
Reducer rubbers
1 USB cable
1 Instructions for
assembly and use
IAN 285919
Model-No. 14133
LED BIKE LIGHT SET
Operation and Safety Notes
LED-FAHRRADLEUCHTEN-SET
Bedienungs- und Sicherheitshinweise
A
3
6
1 2
4 5
7
8
lock
B
