Crosley Furniture CO6310 User manual

Outdoor Sling Chaise Lounge
CO6310

PART LIST
A B C D E
Left Leg
1 PC
Right Leg
1 PC
Left Back Leg
1 PC
Right Back Leg
1 PC
Seat
1 PC
F G H I
Back
1 PC
Support Tube
1 PC
Middle Pole
2 PCS
Plastic Spacer
2 PCS
HARDWARE LIST
#1 #2 #3 #4 #5
M6*18mm
M6*15mm
M6*10mm
Bolt
2 PCS (Extra 1)
Medium Bolt
18 PCS (Extra 1)
Short Bolt
2 PCS (Extra 1)
Barrel Bolt
2 PCS (Extra 1)
Plastic Cap
28 PCS (Extra 1)
#6 #7
M6mm
Nut Cap
4 PCS (Extra 1)
Allen Wrench
2 PCS (Extra 1)
2

Step 1.
Attach back (part F) to seat (part E) using short bolts (part #3),
barrel bolts (part #4) and allen wrenches (part #7).
Remove all protective caps from seat (part E).
NOTE: Please don't fully tighten bolts until unit is fully assembled.
3

Step 2.
Insert left back leg (part C) into left leg (part A) and right back leg
(part D) into right leg (part B) using plastic spacer (part I). Secure
assembled unit (parts A, B, C, D & I) using bolts (part #1)
and allen wrench (part #7). Attach plastic cap (part #5) and nut cap
(part #6) to wheel on back legs (parts C & D). Insert plastic caps
(part #5) into back legs (parts C & D).
NOTE: Please don't fully tighten bolts until unit is fully assembled.
Step 3.
Carefully place assembled unit (parts A & C) on a soft flat surface.
Attach seat (part E) to assembled unit (parts A & C) using medium
bolts (part #2), plastic caps (part #5) and allen wrench (part #7).
NOTE: Please don't fully tighten bolts until unit is fully assembled.
4

Step 4.
Attach seat (part E) to assembled unit (parts B & D) using medium
bolts (part #2), plastic caps (part #5) and allen wrench (part #7).
NOTE: Please don't fully tighten bolts until unit is fully assembled.
Step 5.
Attach support tube (part G) to seat (part E) using medium bolts
(part #2), plastic caps (part #5) and allen wrench (part #7).
NOTE: Please don't fully tighten bolts until unit is fully assembled.
5

Step 6.
Attach middle pole (part H) to legs (parts A & B) using medium bolts
(part #2), plastic caps (part #5) and allen wrench (part #7).
NOTE: Please don't fully tighten bolts until unit is fully assembled.
Step 7.
Attach middle pole (part H) to back legs (parts C & D) using medium
bolts (part #2), plastic caps (part #5) and allen wrench (part #7).
NOTE: Please don't fully tighten bolts until unit is fully assembled.
6

Step 8.
Attach plastic caps (part #5) and nut caps (part #6) to back (part F).
NOTE: Please fully tighten all bolts at this time.
7