Crosley CF3027 User manual

Top Panel
1 PC
Left Frame
1 PC
Right Frame
1 PC
Bottom Panel
1 PC
Back Rail
1 PC
Front Rail
1 PC
Shelf Frame
1 PC
Drawer Left
Panel
2 PCS
Drawer Right
Panel
2 PCS
Drawer Front
Panel
2 PCS
Drawer Back
Panel
2 PCS
Drawer Bottom
Panel
2 PCS
Partition Panel
1 PC

ADDITIONAL TOOLS (Not Provided)
Note: It is not recommended to use power tools during assembly.
Phillips Head Screwdriver
Note: Wood dowels are intended for alignment. Additional clearance between
wood dowel and pre-drilled hole is intentional for ease of assembly.
2 PCS
Screw
2 PCS
2 PCS 1 PC

Please do not use tools to assemble this unit unless specifically indicated.
Step 1. Insert drawer left panel (part J) and drawer right panel (part K) into drawer
front panel (part I) pull down to lock. Slide drawer bottom panel (part M) into
grooves of assembled unit (parts I, J & K). Attach drawer back panel (part L)
to assembled unit (parts J, K & M) using screws (part #3) and phillips head
screwdriver. Repeat for remaining drawer.

Step 2. Attach shelf frame (part G) to left frame (part B) using short bolts (part #2),
barrel nuts (part #4), allen wrench (part #8) and phillips head screwdriver.
Step 3. Attach bottom panel (part D) to left frame (part B) using short bolts (part #2),
barrel nuts (part #4), allen wrench (part #8) and phillips head screwdriver.

Step 4. Insert back rail (part E) into left frame (part B) and right frame (part C) and lock
the hardware. Attach shelf frame (part G) and bottom panel (part D) to right
frame (part C) using short bolts (part #2), barrel nuts (part #4), allen wrench
(part #8) and phillips head screwdriver.
Step 5. Carefully turn unit upright. Attach front rail (part F) to frames (parts B & C)
using long bolts (part #1), barrel nuts (part #4), allen wrench (part #8) and
phillips head screwdriver.

Step 6. Attach partition panel (part H) to rails (parts E & F) using wood dowels (part #5),
screw (part #3),phillips head screwdriver and lock the hardware.
Step 7. Carefully lay down unit on a flat, soft surface, such as carpet. Attach locking
casters (part #6) and casters (part #7) to frames (parts B & C) using wrench
(part #9).

Step 8. Carefully turn unit upright. Attach top panel (part A) to assembled unit (parts B,
C & H) and lock the hardware.
Step 9. Slide assembled drawers into place.