TH2-RGH
Installation Instructions
151229533
15122953 2
Replacement Parts
2
This valve is designed to fit into a
wall that is 2-3/4” to 3 -1/4" from
finished wall to the back of the valve.
If necessary,extensions can be
purchased separately.
1
Turn off the water supplies. Install the
valve so the finished wall will fit
between the markers on the mud
guard.
2
Using mounting holes secure the
valve making sure the "UP" label
outlet is on top. Facing the valve,
the hot supply must be on the left
and the cold on the right.
3
5
Warning：If soldering is required
for any connection,remove the
cartridge and check valve
assemblies before soldering.
6
Connect top outlet with proper
fittings.Note: it is suggested that you
anchor all water lines.
Installation completed.
8
2-3/4＂ - 3-1/4" 2-3/4＂ - 3-1/4"
Best if finished wall
is flush to this surface.
4
Connect valve body 3/4-NPT inlets
to water supplies using the proper
fittings. Warning: This valve does
not offer a back-to-back installation
option.
Warning
7
1.Pressure test and flush the valve.
a. Prior to testing, remove cartridge and check valve assemblies.
b. Plug the outlet and check for leaks.
c. After testing, flush system.
d. Remove shower outlet plug. Re-install the cartridge and check valve assemblies.
2.Check for leaks.
Mounting hole
2
a b c d
2
1
3
4
5
6
7
Ordered Separately if needed
NO. Description Part NO.
1
2
3
Extension kit 9K3172
Cartridge 5K217404PL
Nut 5K217405NT
Check valve 5K013107PL
4
6
5
Temperature control rings
Complete Mud Guard
5K202716PL
5K202720PL
7
Cartridge 5K202711NT
This thermostatic valve has been preset at the factory
to deliver water at a maximum of 120ºF. If you would
like to change this setting please refer to the
temperature change instructions noted in the trim
installation instructions for this valve.
