Crosswater Belgravia US-A11 User manual

Parts supplied:
Ø8.0mm
2x
B1 - 2
Tools required:
2x
2x
4x 4x
A9,A11
A38
A9,A11
A38
12
center of mirror
top of mirror
Determine the final installation position, mark the fixing hole positions in pencil. Using an8mm drill bit, drill holes on the
marked positions. Note: In the event that the
wall fixings supplied are inappropriate for the
wall, please source alternatives.
Cleaning Instructions
The safest cleaner for a mirror is a soft, clean cloth and warm water. If using a glass or mirror cleaner, be sure it does not contain
ammonia or vinegar.
Never spray any cleaner directly on to a mirror. Spray the cleaner on to a soft cloth and then wipe the mirror.
The mirror edges are treated with a specially formulated sealant designed to protect the mirror edges from contaminants and discoloring.
Care should always be taken to avoid getting the edges and backing of the mirror wet. Should they get wet, dry immediately.
8¼”
9”
Belgravia Frame Mirror
US-A11
Installation Instructions
IMPORTANT:
Please check this product immediately to ensure that it is complete
and check for damage that may have occurred during transport.
Note: Damage claims cannot be made during or after installation.
Please read these instructions carefully and keep for future reference

B2 - 2
34
5
Keep the stainless screw exposed 8mm outside the wall.
Mount the mirror onto the wall by hanging the bracket of mirror
onto the exposed screws.
Check if it is stable.
If not,please re-adjust the exposed length of screws and
use the washers supplied if needed .
8mm
Toll free number: 844-XWATER-1 (844-992-8371) tel: [phone] fax: [phone]
Warranty: This Crosswater London product is covered by a limited lifetime warranty. For
full details, terms and conditions please visit our website.
For further information contact Crosswater London , 393 Fortune Blvd., Milford, MA 01757
www.crosswaterlondon.com
email: tec[email protected]
Issue date: 15092019