CANVASS FURNITURE RANGE
IMPORTANT - Advice and safety - Please read before installation
Tools & equipment needed: Phillips screwdriver, Spirit level, Ruler/tape measure.
1
Canvass Leg Set x2
x12
x2 x2 x4
Please read these instructions carefully before starting installation
and keep in a safe place for future reference. ENSURE the room is well
heated and ventilated.
Check the contents of the pack carefully before installation. Crosswater will
If any fault is found with materials or workmanship, it must be reported
immediately to the manufacturer. Remedial action will be taken, based on
information received, on condition that: 1. Full details are supplied to the
manufacturer is informed of any damage/shortages prior to installation. 4. The
product has not been installed, or attempts have been made to install.
We do not accept responsibility for any problems that may occur through
incorrect installation.
Advice & Safety
This product should only be installed by a suitably quali ed Plumber/installer.
Should the installation be completed by a non-quali ed person any product
guarantee maybe considered invalid. For a claim made under our warranty
written certi cation of your installers quali cations can be required.
It is advised that all doors and drawers are removed prior to tting to avoid
unnecessary damage occurring.
It is recommended that the furniture and accessories are installed after tiling,
be easily removed if required in the future.
This document has been prepared for your guidance, you must exercise due
care at all times.
Please note that some units are heavy. Always take care when lifting, and
follow health and safety guidelines. It is recommended that 2 people carry out
the installation of larger basin/vanity units over 30Kgs gross weight.
Warning! ! Please check for any hidden pipes or electrical cables before drilling
holes in the oor or walls.
When using power tools always follow the manufacturer’s user instructions.
the wall can take weight of units detailed above. Before installing a wooden
bathroom unit into a new property, extension or recently plastered room we
strongly advise the building/room is completely dry, well ventilated and
adequately heated.
Care & Cleaning
Ceramic, glass and cast mineral marble basin products should be cleaned
regularly with warm soapy water, then rinsed with clean water and, if desired,
dried and polished with a soft cloth. Lime scale deposits can be removed using
a 50:50 solution of warm water and lime scale remover and soft clean cloth.
Regularly clean worktop, carcass, legs and drawer using a well wrung chamois
year using a natural bees wax.
Do not use abrasive cleaners or bleach in this will permanently damage the
lacquered and varnished surfaces.
If any mainten
LV CVLEGS
0,4 Kgs
