Current Single TrueLumen PRO User manual

SingleTrueLumen PRO
INSTALLATIONGUIDE
www.current-usa.com
• Never attempt repairs yourself; return the appliance to an authorized service facility for service or discard the appliance.
• Never plug in a wet cord. If a plugged in unit or socket does get wet, DON’T touch it. Instead, promptly disconnect the fuse or circuit breaker that
• Close supervision is necessary when any appliance is used by or near children.
an unsafe condition and will void your warranty.
• Do not operate at temperatures above 50º Celsius or 122º Fahrenheit.
may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
• Do not look directly into the LEDs.
IMPORTANT WARNINGS | SAVE THESE INSTRUCTIONS
This is NOT a page of legalese. It contains important safety information that you should read and save for future
reference. Remember you can always quickly reference instructions for all Current products on our website.
Canopy Option:
1. Unpack your LED kit and remove the two swivel canopy brackets with screws.
2. Attach the swivel brackets to each end of the light xture using the screws provided and a screwdriver.
3. Determine mounting location. Secure swivel brackets and LED strip to inside of canopy with screws provided.
We have included two installation instruction methods for installing the LED’s over your aquarium.
#1 Canopy Option - using included swivel brackets for mounting to an aquarium canopy
#2 Tank Mount Option - using the optional aluminum docking mounts for setting the light directly on the tank.
Attach to canopy
4. Follow connection instructions on next page.

SingleTrueLumen PRO
INSTALLATIONGUIDE
Tank Mount Installation
1. Place the optional aluminum docking mounts #3043 on the LED strip as shown below. Attach using the
provided screws and screwdriver.
2. After the mounts have been securely attached, simply set the LED strip on the edge of tank as shown below.
4. Follow connection instructions as shown below.
Connecting TrueLumen PRO LED strips
1. If using an optional inline dimmer #1672 or Ramp Timers, plug dimmer/timer into plug on LED strip.
LED Dimmer
2. Connect either end of LED strip or dimmer/timer into a 24VDC power supply rated for the minimum
number of watts of your LED strip. Plug transformer into a GFCI approved outlet.
LED Dimmer
Transformer
3. If connecting multiple strips, connect end of LED strip into splitter #1671 and dimmer, then plug splitter
directly into timer or power supply. Ensure the power supply is rated for the minimum number of watts
total for all LED strips. Plug transformer into a GFCI power supply.
Transformer
Dimmers
3-Way Splitter
LEDs
Register your product at www.current-usa.com