Curt Group Aries 2074113 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •2074113-INS-RA •PAGE 1
INSTALLATION MANUAL 2074113
Parts List
1Driver / left Rocker Step
1Passenger / right Rocker Step
4Driver / left
mounting bracket, universal
4Passenger / right
mounting bracket, universal
16 Flat washer, M8
16 Lock washer, M8
16 Hex bolt, M8
Tools Required
Torque wrench Wrench
Socket, 13mm Flathead screwdriver
Maintenance
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Product Photo
Front
Rear
Level of Difficulty
Easy
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To help prevent damage to the product or vehicle, refer to the specified
torque specifications when securing hardware during the installation process.
Product Registration and Warranty
CURT Group stands behind our products with industry-leading warranties.
Provide feedback and help us to improve our products by registering your purchase at:
warranty.curtgroup.com/surveys
Torque Specifications*
Metric
M6 bolt 3 ft-lbs.
M8 bolt 7 ft-lbs.
M10 bolt 16 ft-lbs.
M12 bolt 28 ft-lbs.
SAE
1/4" bolt 3 ft-lbs.
5/16" bolt 7 ft-lbs.
3/8" bolt 16 ft-lbs.
7/16" bolt 20 ft-lbs.
1/2" bolt 28 ft-lbs.
Use above torque setting unless otherwise noted

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •2074113-INS-RA •PAGE 2
Step 1
Starting on the driver side, locate
the four mounting points along the
rocker panel of the vehicle.
Step 2
Lift the Rocker Step into position and
align the brackets on the Rocker Step
with the mounting points on the vehicle.
Secure all mounting points using two
M8 hex bolts, lock washers and flat washers.
Tighten all hardware to the
recommended torque specifications
listed in the table on the first page.
Step 3
Repeat steps 1 through 2 on the
passenger side of the vehicle.
Congratulations on the installation
of your new ARIES Rocker Steps.
With the rocker steps installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on
the first page of this instruction manual.