Curt Group Aries AL235045 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •AL235045-INS-RA •PAGE 1
INSTALLATION MANUAL AL235045
Parts List
1Driver / left 4" side bar
1Passenger / right side bar
6Mounting brackets, universal
12 Hex bolt, M8
30 Flat washer, M8
12 Lock washer, M8
18 Nylock nut, M8
Torque Specifications
Metric
M6 bolt 3 ft-lbs.
M8 bolt 7 ft-lbs.
M10 bolt 16 ft-lbs.
M12 bolt 28 ft-lbs.
SAE
1/4" bolt 3 ft-lbs.
5/16" bolt 7 ft-lbs.
3/8" bolt 16 ft-lbs.
7/16" bolt 20 ft-lbs.
1/2" bolt 28 ft-lbs.
Use above torque setting unless otherwise noted
Tools Required
Ratchet Socket set
Torque wrench Level
Level of Difficulty
Easy
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Product Photo
Brackets and Hardware
Front
Front
Middle
Rear
Rear
Product Registration
CURT Group stands behind our products with industry leading warranties.
You can help us continue to improve our product line and help us understand
your needs by registering your purchase by visiting:
warranty.curtgroup.com/surveys
At CURT Group, customer is king. We value your feedback and we use that information to make
improvements on our products. Please, take a minute and let us know how we are doing.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •AL235045-INS-RA •PAGE 2
Step 1
Beginning on the driver side, locate
the three mounting tabs along the
bottom edge of the vehicle.
Step 2
Starting at the front mounting location,
remove any debris from the factory studs.
Attach a mounting bracket using
an M8 nylock nut and flat washer.
Repeat this process for the
middle and rear mounting locations.
Snug the hardware,
but do not fully tighten.
Step 4
Congratulations on the installation
of your new ARIES 4" Big Step™.
With the side bars installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on
the first page of this instruction manual.
Step 3
Place the driver-side side bar onto the
mounting brackets and align the mounting
points. Ensure the rivet nuts on the bottom
of the side bar line up with the brackets.
Secure the side bar to the brackets
using a M8 hex bolt, lock washer and flat
washer at each mounting location.
Snug the hardware,
but do not fully tighten.
Repeat steps 1 through 3 for the
front, middle and rear mounting
locations on the passenger side.