CURTMFG.COM •NEED ASSISTANCE? •877.287.8 634 •45952-INS-RA •PAGE 2
Step 2 - Determine Required Ball Height
Determine the proper ball height by leveling the trailer and measuring
from the bottom of the trailer tongue to the ground, see below.
Find the hole closest to that measurement on the adjustable shank (#1).
The dual ball (#2) will be centered on that hole.
TrailerCoupler
Rebellion™XD
Level Ground
Drop
Rise
Vehicle
Receiver
Tube
BALL HEIGHT
Step 3 - Attach the Dual Ball
Based on the determined ball height, slide the dual ball mount
onto the shank and align with the proper hole locations.
Angle the mount slightly upwards and press in toward the shank.
Insert a pin (#3) into the top mount hole first. To pin the bottom
mount hole, apply downward force to the mount, and slide
the second pin into place.
Note: The highest mounting position will require the bottom
pin to be installed first with the mount angled downward.
Then, apply force upwards to install the second pin.
Secure all pins with the clips included with your Rebellion™XD.
The pins included with your Rebellion™XD shank are specifically
engineered for this system. If replacement pins are needed, they
must be replaced with original factory mount pins (CURT# 45959).
Before you Begin
The Rebellion™XD dual ball accessory has a built-in anti-rattle feature
located in the channel on the backside to keep your towing system quiet.
See the recommended assembly instructions for optimal performance.
Step 1 - Insert into the Trailer Hitch
Begin by installing the shank (sold separately) into the trailer hitch
receiver and secure it with a hitch pin and clip (sold separately).
ASSEMBLY & SETUP
Parts List
Item Qty Description
1 1 Adjustable shank*
2 1 Dual ball
3 2 Pin*
4 2 Clip*
*Sold separately
1
3
2
4
