Curtis XP 900 Operating instructions

INSTALLATION & OWNER’S MANUAL
Rev. B, p. 1 of 2
revised: 4-11-2017
POLARIS RANGER XP 900, CREW XP 900,
XP 1000 EPS, and CREW XP 1000 EPS
WIPER KIT p/n: 1POLXP900CVWPR
p/n: IM-PXP900CVWK
The contents of this envelope are the property of the owner.
Be sure to leave with the owner when installation is complete.
Windshield Wiper
shown installed
California Proposition 65
WARNING
Engine exhaust, some of its constituents,
certain vehicle components and fluids,
contain or emit chemicals known to the
State of California to cause cancer and birth
defects or other reproductive harm.

p. 2 of 2
1. WIPER INSTALLATION
1.1 Per fig. 1.1, mount the wiper motor and the flat cover
plate to the inside surface of the windshield. CAUTION:
The inside surface of the windshield is coated with a
plasticized safety film. Use care to avoid scratching the
inside surface.
Sandwich the windshield where shown. Orient the bosses
on the left-most plastic washers as shown (pointing to-
wards the windshield location/placement). NOTE: if the
bosses do not fit into the holes in the windshield, the in-
stallation can still be completed as is.
1.2 At the installer’s discretion, create an opening (a ver-
tical rectangle) in the dash for the switch to mount into.
1.3 At the installer’s discretion, run the wiring harness
neatly along the upper windshield support and down the
front ROPS tubing and eventually connecting to the vehi-
cle’s battery.
SERVICE PARTS
Fig. 1.1
boss on bushing
windshield
boss on bushing
windshield
PARTNUMBER:DESCRIPTION:
9SV‐00014WIPERARM(QTY.:ONE)
9SV‐00035WIPERBLADE(QTY.:ONE)
9SV‐00096SWITCHFORWIPER(QTY.:ONE)