CYP PUV-44XPL-AVLC User manual

Driver User Guide
PUV-44XPL-AVLC
4×4 4K UHD+ HDMI over HDBaseT Matrix with AVLC

CONTENTS
1. Introduction ....................................................... 1
2. Driver Properties ................................................ 1
3. IP Network connection ....................................... 1
4. device specific command .................................. 2
4.1 Set Power .................................................... 2
4.2 Save Preset ................................................. 2
4.3 Recall Preset ................................................ 2

1
1. INTRODUCTION
This driver has been designed to provide two-way control of the CYP 4x4
A/V matrix, via RS232 or TCP/IP.
2. DRIVER PROPERTIES
The property of this driver is shown below
Figure 1: Driver Properties
• Driver Version Driver version number
• Debug Mode Support use only
• Debug Level Support use only
• Command Delay Milliseconds a delay of millisecond between
commands
• Connected To Network Shows operational status of driver
3. IP NETWORK CONNECTION
If an IP driver used, the IP address of the A/V Matrix is entered in the usual
way in connections -> Network.

2
4. DEVICE SPECIFIC COMMAND
In addition to the usual A/V Matrix functionality supported by Control4, there
are a number of device specific commands for the A/V Matrix switching.
4.1 Set Power
• State On or Off
4.2 Save Preset
• Preset 1 to 8
4.3 Recall Preset
• Preset 1 to 8