Cypress CY3280-BSM User manual

CY3280-BSM UNIVERSAL CAPSENSE®SIMPLE BUTTON MODULE KIT
QUICK START GUIDE
1. Insert the kit CD in the CD drive.
2. Install kit content, PSoC Designer, PSoC
Programmer, and Bridge Control Panel.
Note The hardware prerequisites for this kit are
the CY3280-20x34 Universal CapSense
Controller (UCC) board and MiniProg1.
1. Connect the CY3280-BSM board to the
CY3280-20x34 UCC board’s P2 connector.
2. In the CY3280-20x34 board, place the
jumper on header J1 to short pins 2 and 3. In
the CY3280-BSM board, place the jumper on
header J2 to short pins 2 and 3.
3. Connect MiniProg1 to the CY3280-
20x34 UCC board’s ISSP connector (J3).
Connect it to your PC using a USB cable.
1. Open PSoC Programmer and click
File > File Load. Browse and load the
CY3280_BSM_20x34.hex file.
2. Click the Connect button.
3. Click the Program button to program the
device.
4. Click the Toggle power button to power
the board.
Note The hex file is located at:
<Install directory>\Cypress\CY3280
BSM\<version>\Firmware\20x34_CSA\
CY3280_BSM_20x34\CY3280_BSM_20x34\
1. When you touch a button, the
corresponding LED on the module board
lights up, indicating the button you
touched.
2. Next, touch the same buttons to turn
off the LED. You can touch multiple
buttons at the same time.
1 2
3 4

© 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of
their respective owners. DOC#: 001-51789 REV *B
www.cypress.com/go/CY3280-BSM
For the latest information about this kit visit
CY3280-BSM UNIVERSAL CAPSENSE®SIMPLE BUTTON MODULE KIT
QUICK START GUIDE
CY3280-BSM Kit Details
Note For more details on code examples, refer to the Readme file.