Cypress PSOC 3 FIRSTTOUCH STARTER KIT User manual

PSOC®3 FIRSTTOUCH™STARTER KIT
QUICK START GUIDE
Out of Box Demo: PSoC Rocks!
Connect the 9-V battery to the board. Wave the kit and view the message,
as shown.
Insert the kit CD and run the CD’s
autorun utility.
Open the guide and install software.
1
2
3
4

© 2009-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. Doc.#: 001-53755 Rev.*D
http://www.cypress.com/go/CY8CKIT-003
For the latest information about this kit, visit
PSOC®3 FIRSTTOUCH™STARTER KIT
QUICK START GUIDE
General-purpose Switch
CY8C3866AXI
CapSense®Proximity Sensor
Accelerometer
CapSense Slider
Voltage Regulator
9-V Battery
USB Mini B
CY7C68013A
28-Pin External
12-Pin Wireless
Thermistor
8 Red LED Outputs
Header
FX2LP High-Speed USB
PSoC 3 Device
Port
I/O (on reverse)
Header
J4 Voltage
Regulator
Source Select
J1 Vddio Power
Source Select
Kit Revision
To know if you are using the latest kit, look for the kit revision in the white sticker at the bottom left
on the back of the kit box. If the revision reads CY8CKIT-003B REV. **, then you own the latest
version. You can also check the silicon marketing part number on the board; the part number
should be CY8C3866AXI-040. This kit is equipped with production PSoC 3 silicon.