Cypress CY8CKIT-030 User manual

PSOC® 3 DEVELOPMENT KIT
QUICK START GUIDE
Remove the PSoC 3 Development Kit from
the package.
Plug the LCD module into port P8.
Plug the USB cable into your PC and the
on-board programming USB port (J1).
Vary the R56 potentiometer. The voltage is
displayed with 16 bits of precision on the
LCD module.
Insert the PSoC 3 Development Kit CD.
Install PSoC Creator and the kit software.
Launch PSoC Creator.
Open the code examples from the Start page.
1
2
3
4
5
6

© 2012-2013 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. Doc. #: 001-83885 Rev. *A
http://www.cypress.com/go/CY8CKIT-030
For the latest information about this kit, visit
PSOC®3 DEVELOPMENT KIT
QUICK START GUIDE
PSoC 3 Development Kit Details
Power Adapter
9-V Battery Boost Converter
Input
Communication USB
10-Pin JTAG/SWD/SWO
Debug and Prog Header
On-board
Programming
USB
24-MHz Crystal
Port D
(CapSense/
Miscellaneous
Port)
32-kHz Crystal
Port E
(Analog Port)
Variable
Resistor/
Potentiometer
RS-232
Interface
Character LCD Interface Switches/LEDs Prototyping Area
CapSense
Reset Button