Dakota Digital VHX Series User manual

Manual # 650393A
VHX-69F-MUS
Dakota Digital VHX Instrument Installation
For 1969-‘70 Ford Mustang
Your new VHX-69F-MUS kit includes:
Installation
Control Box
Ford
Speed Adapter
CAT5 Cable
Universal
Sender Pack
Installation
Manuals
VHX Display
1. Remove the instrument system from the dashboard. Be sure to save the hardware for reassembly.
(2) 6-20 x ¾”
Counter Sunk
screws

Manual # 650393A
2. Remove the stock gauge cluster from the
bezel and save the three separator
pieces and the hardware for reassembly.
3. Reinstall the three separator pieces
onto the bezel.
4. Align the VHX system on the separator pieces and use
the stock hardware to secure to the bezel. The bottom
two mounts of the Speed and Tach assembly will use
the supplied 6-20 x ¾” counter sunk screws as shown
by the oversized arrows.
OIL
&
WATER
SPEED
&
TACH
FUEL
&
VOLTS

Manual # 650393A
5. With the VHX system mounted to the bezel, the cluster should be secure on all
sides with no movement.
7. Connect the ribbon cables with the appropriate labeled connector (black arrows)
and also connect the CAT5 cable to the system (white arrow). As the assembled
cluster is installed into the dash, take care when routing this cable to the control
box to prevent damage.

Manual # 650393A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
8. Reinstall the cluster into the vehicle using the original hardware and refer to the
main manual for wiring instructions to complete the VHX installation.