Dakota Digital VLK-51F User manual

Manual # 650407
VLK-51F
Dakota Digital VHX Clock Installation
For ‘51 Ford Car
Your new VLK-51F kit includes:
Installation
CAT5 Cable
VHX Clock
Installation Manuals
3-Pin Switch Harness
1. Remove the original clock and also the
nut for the ash tray that shares the stud
with the clock mounting tab. Place two of
the nuts aside for reassembly.

Manual # 650407
4510 W. 61st St. N., Sioux Falls SD 57107
Phone: [phone] Fax: [phone]
www.dakotadigital.com
[email protected]
3. Connect the CAT5 cable and the 3-pin
switch harness to the clock. Route the
other ends to the VHX control box. Two
of the buttons on the VLK clock can be
used as SW1 and SW2 for the VHX
instrument system. Refer to enclosed
clock operating manual for these
connections and setup.
2. With the original clock removed, carefully maneuver the VLK clock in place from behind
the dash while lining up the mounting holes of the VLK clock to the studs behind the
dash making sure not to scratch the chrome bezel or clear lens, then secure the clock
in place by using the stock mounting nuts. Note: the ash tray mounting tab should be
between the VLK clock and the back side of the dash.