Dakota Digital HDX-68C-CVL User manual

Manual # 650577B
HDX-68C-CVL
Dakota Digital HDX Instrument Installation
For 1968 Chevelle, Malibu and El Camino
Your new HDX-68C-CVL kit includes:
Installation
Control Box
Main Harness
Universal Sender
Pack
Installation Manuals
HDX Display
Buzzer
1. Remove the stock gauge panel from the car.
Gear Block-off
Lens

Manual # 650577B
2. Remove the five screws holding the gauge cluster to the dash panel. Save this hardware as it will be
reused.
3. Remove the seven screws that hold the stock gauges to the lens spacer. Save this hardware as it will
be reused.
4. Remove the stock lenses from the lens
spacer by removing three screws from the
front of each lens. The stock lenses are
removed since the new HDX kit features hard
coated clear lenses.

Manual # 650577B
5. This step is optional for automatic transmission bezels only. If you purchased a separate GSS
universal gear kit from Dakota Digital, the gear position can be displayed in the HDX message
centers; therefore the stock gear position indicator can be removed.
The stock gear position indicator will slide out from its location. Align the notches in the supplied
block off plate with in the stock housing. Use silicone to attach the block off.
6. Install the HDX system into the stock lens spacer by securing the system to the spacer by reusing the
seven screws removed in step 3.

Manual # 650577B
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
8. Re-install the cluster into the vehicle using the factory hardware and refer to the main manual for
wiring instructions to complete the HDX installation.
Buzzer Connector
7. Connect the provided Main Harness and the Buzzer (optional for audio feedback) to the back of the
HDX system.