Dakota Digital VHX-1023 User manual

Manual # 650501A
VHX-1023
Dakota Digital Universal VHX Instrument Installation
Your new VHX-1023 kit includes:
Installation
Control Box
(5x) L-Brackets
and Thumb Nuts
CAT5 Cable
Universal Sender Pack
Installation Manuals
and Cutout Template
VHX Display
1. Use the provided template to mark out the opening needed to fit the VHX display. Ensure there is
adequate clearance behind the desired mounting location. The display unit needs approximately
2 1/8” of depth behind the dash.
(5x) Mounting Studs
(5x) Nuts and
Lock Washers
Switch Assembly

Manual # 650501A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
2. With the appropriate opening cut, choose
the best locations for using 4-5 of the
provided L-brackets to secure the VHX
system to the dash. Remove the existing
screws in those locations and secure the
studs in place of the screw by using the lock
washers and nuts.
4. Attach the provided CAT5 Cable to the back of the VHX display and carefully route the other end to
the control box mounting location and refer to the main manual for wiring instructions.
3. Place the VHX display into the dash and attach the L-brackets to the back of the display using the
provided thumb nuts.