Dakota Digital VHX-54C-PU User manual

Manual # 650322A
VHX-54C-PU
Dakota Digital VHX Instrument Installation
For ‘54 and ‘55 “First Series” Chevy pickup systems
Your new VHX-54C-PU kit should include:
Installation
1. Remove the stock gauges from the dash. They are held in place by three nuts on the tabs of the
stock gauge housings. Save the nuts as they will be re-used to secure the new VHX kit.
2. Remove the clear protective tape from the new
VHX gauges to prepare them for installation.
Secure the new VHX gauges back into the
dash re-using the original nuts, six total.The
photo, at right, is of the ‘47-‘53 Chevy Pickup
but the idea is the same, except the ’54 has
three mounting tabs instead of four.
Control Box
(1) 36”CAT5 Cable
(1) 12”CAT5 Cable
Universal Sensor
Pack
Installation Manuals
VHX Displays
Switch Assembly

Manual # 650322A
3. Connect the two halves of the new VHX system with the supplied 12” CAT5 cable. Also, route
the 3’ cable towards the control box location and connect it to the display.
4. Display installation is complete, refer to the main manual for wiring instructions to complete the
VHX installation.
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
3’ Cable
12” Cable

Manual # 650322A