Dakota Digital VHX-1018 User manual

Manual # 650419A
VHX-1018
Dakota Digital Universal VHX Instrument Installation
Your new VHX-1018 kit includes:
Installation
Control Box
(4x) L-Brackets
and Thumb Nuts
CAT5 Cable
Universal Sender Pack
Installation Manuals
and Cutout Template
VHX Display
1. Use the provided template to mark out the opening needed to fit the VHX display. Ensure there is
adequate clearance behind the desired mounting location. The display unit needs approximately two
inches of depth behind the dash.
Switch Assembly

Manual # 650419A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
2. With the appropriate opening cut, place the VHX display into the dash and attach the four (4) L-
brackets to the back of the display using the provided thumb nuts.
3. Attach the provided CAT5 Cable to the back of the VHX display and carefully route the other
end to the control box mounting location. Remove the protective tape from the lens and refer
to the main manual for wiring instructions.