Dakota Digital HDX-47C-PU User manual

Manual # 650565A
HDX-47C-PU
Dakota Digital HDX Instrument Installation
For 1947-‘53 Chevy Pickups
Your new HDX-47C-PU kit includes:
Installation
Control Box
8x Screws
Main Harness
Universal Sender
Pack
Installation Manuals
HDX Display
1. Remove the stock gauges from the dash. Each gauge is held in place by four nuts on studs on
the back of the dash. Save the nuts as they will be re-used to secure the new HDX kit.
Foam Gaskets
Buzzer
2X Mounting Tabs
Interconnect
Harness

Manual # 650565A
2. Your HDX kit comes with two variations for lower
mounting tab locations, choose the location you need
by aligning the four mounting tabs to the studs in the
dash. Once the correct mounting location is decided;
secure the tab to the housing by lining up the thru-holes
in the tab to the holes in the housing and using the
supplied screws (4 per gauge). Repeat on second
gauge so both Speed and Tachometer have the
mounting tabs in the correct location.
3. Place the supplied foam gaskets over the new chrome bezel.
4. Secure the new HDX Instruments back into the dash re-using the original nuts, eight total.
Foam Gaskets

Manual # 650565A
6. Connect the provided main harness and the buzzer (optional for audio feedback) to the back of
the HDX system.
Buzzer Connecter
5. Connect the provided interconnect harness to the back of the HDX system.
Main Harness

Manual # 650565A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
7. Refer to the main manual for wiring instructions to complete the HDX installation.