Dakota Digital HDX-66C-NOV User manual

Manual # 650593A
HDX-66C-NOV
Dakota Digital HDX Instrument Installation
For 1966-‘67 Chevy Nova
Your new HDX-66C-NOV kit includes:
Installation
Control Box
Main Harness
Universal Sender
Pack
Installation Manuals
HDX Display
Buzzer
(x7) #6-20x1.25” Screws
(x5) #8-18x.375” Screws
(x7) #6 Washers
1. Remove the stock gauges from the dash. Disassemble the stock instrument system by removing the
seven (7) screws holding the instrument housing to the bezel.

Manual # 650593A
Buzzer Connector
4. Connect the provided Main Harness and the Buzzer (optional for audio feedback) to the back of the
HDX system.
3. Place the HDX system into the bezel, taking care to align all mounting holes. Using the
seven (7) provided #6-20x1-1/4” screws and washers; secure the gauges to the bezel. Pay
special attention to align all visible surfaces before tightening the provided hardware. Some
bezels may be bowed and not perfectly straight, requiring slight adjustments.
2. Detach the lens from the bezel and separator plate by removing the two (2) screws shown below.
The only item to be reused is the original front bezel and hardware.

Manual # 650593A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
6. Refer to the main manual for wiring instructions to complete the HDX installation.
5. Secure the cluster to the dash using the five (5) provided #8-18x.375” screws at the base of the
bezel; use the four (4) factory flat head screws at the top of the bezel
(4) Factory screws
(5) Provided screws