Dakota Digital VHX-1200 User manual

Manual # 650432B
VHX-1200
Dakota Digital VHX Instrument Installation for Marquez Designs 1967-‘69 Camaro Dash
Your new VHX-1200 kit includes:
Installation
Control Box
CAT5 Cable
Installation Manuals
Cut Template
VHX Display
1. This cluster is designed to be a direct fit to Marquez Designs 1967-’69 Camaro dash. If this cluster
is going to be mounted universally, skip to Step 4 and use the provided template to mark the
opening needed to fit the VHX display in the desired location. Ensure there is adequate clearance
with overall size including behind the desired mounting location; the display requires approximately
2” of depth.
Switch harness
Universal Sender Pack

Manual # 650432B
2. Attach the VHX system to the fiberglass insert using the provided hardware from Marquez Design
as well as the L-bracket. The lower section of the VHX system will mount to the lower half of the
dash using hardware also provided by Marquez Design.
3. With the VHX system mounted to the fiberglass dash, attach the provided CAT5 Cable and
the 3-Pin Switch Harness to the back of the VHX display. Carefully route the other ends to the
control box mounting location and refer to the main manual and manual 650431 for wiring
instructions and operation.
L-Bracket

Manual # 650432B
5. Ensure the cut out template is flat and secure before marking the cut line so the
opening will be the right size and location.
4. Use the diagram below to verify the measurements will fit the desired mounting
location.
6. Mount the VHX system to your liking using any of the 1/4”-20 threaded holes. No hardware or
brackets are provided for universal mounting.

Manual # 650432B
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov