Dakota Digital Retrotech RTX-64C-PU User manual

Manual # 650668
RTX-64C-PU
Dakota Digital RTX Instrument Installation
For 1964-‘66 Chevy Pickups
Your new RTX-64C-PU kit includes:
Installation
Control Box
7x Screws
Main Harness
Universal Sender
Pack
Installation Manuals
RTX Display
Buzzer
1. Remove the stock gauge cluster from the dash.
Foam Tape
Switch Assembly

Manual # 650668
3. Secure the RTX system to the bezel with the seven supplied screws.
2. Remove the stock gauges, separator plate, and lens from the bezel. The only item to be reused is
the original front bezel; the other pieces can be set aside. Cut the supplied foam tape into six
pieces, so each is about two inches long. Stick the foam strips on the angled part of the inside edge
of the bezel. The lens will compress against any foam above the edge, which helps prevent lens
rattles.
2”
Foam Strips

Manual # 650668
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
5. Re-install the cluster into the truck and refer to the main manual for wiring instructions to
complete the RTX installation.
4. Connect the provided harness and the buzzer (optional for audio feedback) to the back of the
RTX system.
Buzzer Connector